Bukh DV24 Manual Start HowTo

  Рет қаралды 32,909

rc2706

rc2706

Күн бұрын

Clip shows how to manually start a Bukh DV24 marine diesel engine using the starting handle.
This particular engine is installed on a Westerley Griffon sailboat.
Manual starting is useful to know if you are off a leeshore in a gale and the batteries have gone flat or the starter motor has packed up.
It takes three attempts to start, but it does finally start.

Пікірлер: 15
@trinitywieltec9996
@trinitywieltec9996 2 жыл бұрын
The reason the decompressor lever is heavy to push down, is because the bolts on the valve cover are too tight !!! Do not use the tool to create more momentum !!! You can easily break stuff. Suggestion: remove the valve cover, and renew the gasket/seal. Gently tighten, just enough so no oil is leaking. Whilst tightening the 2 bolts on top, keep moving the lever up and down. You will feel it going more difficult once the bolts tighten. Starting the engine manually should be very easy....🙂
@kermitthefrog6363
@kermitthefrog6363 8 ай бұрын
Thanks for the video!! I think I will try this in the spring!
@mrvegardeide
@mrvegardeide 3 жыл бұрын
Great! Thanks for sharing. I’ve got the same engine in my boat
@rafiqbabashov6873
@rafiqbabashov6873 3 жыл бұрын
Ssdghkb
@devpatel1548
@devpatel1548 Жыл бұрын
Hi sir Can I help you
@rollingrecords9019
@rollingrecords9019 Жыл бұрын
That water pump how do you get it off
@rc2706
@rc2706 Жыл бұрын
I took the water pump off earlier this year. I had to remove the flywheel to access all the bolts holding the pump in place.
@rollingrecords9019
@rollingrecords9019 Жыл бұрын
@@rc2706 I found a huge needle nose pliers been at a 90° angle. Got it right out.
@KhanKhan-dh1ox
@KhanKhan-dh1ox 11 ай бұрын
Amizing
@supereliptic
@supereliptic 3 жыл бұрын
We have a Bukh DV20 and have never been able to get it to manually start. Aside from having the batteries on and the engine in neutral, do you think there anything else we need to do to get this going? Ps: We have the compression leaver set to open so maybe we are just timing it wrong ?
@rc2706
@rc2706 3 жыл бұрын
The idea is to set the compression lever from open to closed whilst the engine is being cranked. Also, if the engine is normally difficult to start in the first place, then it may be very difficult to start it by manual cranking.
@Nargiskalhorokalhoro
@Nargiskalhorokalhoro 11 ай бұрын
How it works
@johnpatchett9909
@johnpatchett9909 2 жыл бұрын
I would advise starting your engine like this unless you want to break your thumb.
@vicentecarrasco3653
@vicentecarrasco3653 Жыл бұрын
what kind of starter is it and how it works?
@OmmerSyssel
@OmmerSyssel 6 жыл бұрын
You have to put full intention in handstarting.
bukh dv20 taking head off to check head gasket.
7:11
Neil Clatworthy
Рет қаралды 4,5 М.
How to service a BUKH DV-20 Diesel motor Ep 11
19:15
King Country
Рет қаралды 18 М.
Миллионер | 1 - серия
34:31
Million Show
Рет қаралды 2,4 МЛН
Bike Vs Tricycle Fast Challenge
00:43
Russo
Рет қаралды 109 МЛН
Crazy Big Old Engines Sounds That Will Amaze You
37:56
Techno Fusion HD
Рет қаралды 1 МЛН
Bukh 10HP seized, 2 years later will it run?
4:57
mjcooke2
Рет қаралды 18 М.
Jahreswartung des BUKH DV 36 - Motor- und Getriebeöl wechseln & Impellertausch.
3:05
Ermano Mötershausen (Ermano)
Рет қаралды 2,4 М.
Bukh 10HP test run
3:17
Matthew King
Рет қаралды 12 М.
Adjusting decompression levers Bukh DV 20
6:53
Erakor
Рет қаралды 3,5 М.
Lifeboat Conversion Ep2: Servicing a Bukh engine [4K]
3:22
Alex Hibbert Originals
Рет қаралды 352 М.
How to service a Bukh DV10 marine engine - Between Sea and Sky [ Ep 20]
17:03
Миллионер | 1 - серия
34:31
Million Show
Рет қаралды 2,4 МЛН