Rebuild a 2CV Engine | Part 2: Assembly | BURTON 2CV PARTS

[@ArtDeLaRenovation]

Thank you, it will help me a lot in the restoration of my 2cv that I'm doing on my youtube channel.

[@martinneumann7783]

Ik heb geen 2CV maar ik vind die techniek hel interessant. Da 's echt cool. Bedankt en groetjes van Duitsland...

[@pierregrosjean7329]

Simple et efficace.Les images sont facilement visibles, bonne lecture de l’ensemble. A la hollandaise bravo!

[@VyantQuijt]

M10 crankcase bolts 45nm M7 cranckcase nuts and bolts 19nm M5 oil pickup bolts 5nm Oil pump cover bolts 13-15nm Oil filter hand tight Oil pressure release valve plug 45nm Oil cooler swivels 10-14nm Cilinder head nuts & bolts 10, 20, 23nm Oil feed line banjo 10-13nm Valve lash 0.2mm Valve cover nuts 5-7nm or 1.5 turns

[@BigDwww]

If you are following this while assembling your engine dont forget to place the steel ignition plate over the crankshaft before the oil cooler is fitted, as you cant fit it after without bending the pipes , they dont show it at all , it may save you a headache,

[@terminateur854]

Magnifique ,merci Burton

[@Tom-zs5mx]

Brilliant video, thank you so much. 😊

[@joeakin464]

trying to get milage added to my "new" Burton motor in my AK400, it purrs like a kitten!!

[@GereDJ2]

No intake or exhaust manifold gaskets? I like some of the special tools, like the oil cooler lower bolt tool.

[@leneanderthalien]

I think this orange painted manifold is a adjustment manifold for right orientation from the heads before they tightening...

[@AurelioMoralez-ic9co]

Hola podría poner un vídeo de como colocar los cables del encendido me urge por favor gracias

[@burton2cvparts]

Hola, Gracias por el consejo. Empezaremos a trabajar en ello.

[@daanspijker8703]

top filmpje, maar toch een gemiste kans om wel de onderdeelnummers keurig bij elke handeling weer te geven maar dan niet de aanhaalmomenten van de moeren en bouten.

[@gaetanozuccarello9802]

☺️😉👍👍👍

[@leosa9820]

Trabalho excelente,mas não gostei do coletor sem tratamento e a cor horrível

[@martinamatt3836]

The down side hear is there is no real chat or explaining on anything and did find a video of an older gentlemen working on an engine he purchased on ebay and he explained everything and had a greater challenge than this factory setup that dose not show true skill in take out rusty screws and worn parts to fix or remove.