Can Am Primary Clutch Inspection 2018 and Newer UTV

[@angelitlo49]

i have a hd9 defender the primary bearing spins great no issues but extremely hard to change gears when in gear once i turn off the engine it changes gears great! what should i look into

[@Hunterworks]

Watch our how to troubleshoot a clutch with a camera and email me the pic that video talks about to [e-mail]

[@WyMaN224]

I have a 2019 x3 and the belt is slipping over the primary in the higher RPM. I scuffed and cleaned the clutches and replaced the belt and am still having issues with it slipping and it won’t come close to top speed with RPMs going way too high. What should I look into?

[@Hunterworks]

Look at the rollers and tops of the flyweights

[@ChadSidor]

I’m trying to diagnose a jerking issue with my 2022 maverick sport. Can u tell me if the primary bearing is supposed to be one way or not cause mine spins both ways. I’m trying to figure out if that normal

[@Hunterworks]

Two way, is this the 1000R version of Sport? If not then I would be looking at the rollers in the secondary clutch, the two roller style fails a lot

[@dallasjohnston3]

Does it matter if the sliding basket isn’t marked when taken apart on a 23 850 outlander taken my clutch off to do some cleaning and the basket fell apart when I was taking it off I should have marked it before even removing the bolt

[@Hunterworks]

good idea but not required to put it back like it was

[@dallasjohnston3]

@@Hunterworks thank you!!

[@McHmMav]

So those rollers don't need changing? Do they not roll? Just slide the missing thickness doesn't effect clutch profor? Just wondering as my rollers have flat spots on one spot, your saying to just turn them and they won't just roll to the flat spot?

[@Hunterworks]

some have round rollers, if flat spotted then need to replace, if the octagon ones then just turn them as they only slide

[@KClem85]

I having issues with mine pulled off and it was full of motor oil??? should not have oil in in correct?? i have ordered a new one like you have in video already. Thanks

[@Hunterworks]

Your engine or transmission seal has failed, if oil you better not crank it up

[@Dan-qt7kq]

Is there a special tool to remove and replace the hexagonal thingys.

[@Hunterworks]

I am sure there is, we do not carry it. Just a punch more or less