Can We Get Rid of the Hop? Proboat Blackjack 1st Run After Prop Shaft Adjustment - 6S

[@mikesrcgarage]

When you drop the strut down into the water it raises the ride height of the hull out of the water... 😊

[@mikesrcgarage]

You are correct but you got it backwards strut down hull goes up dry boat, strut up hull goes down wet boat!

[@MarksAultimateRC]

Probably because it's opposite on a real boat with a stern drive, which is where my boating experience is. Raise the lower unit to get the hull out if the water, lower to get it in the water. But this is a direct d shaft drive, so that's what makes it different.

[@MarksAultimateRC]

Thanks for watching, 8s run will be posted soon. Hopefully done adjusting whichever way it should go.

[@SakibAhsanTamim]

Hello "Aultimate RC" I saw that in your channel have some problems. For these problems your channel is not much growing. Not getting much engagement. If you can solve these problems, Your channel will get more engagement. If you can give me permission I can tell to you about these problems. Can I tell here or email? Okay?

[@MarksAultimateRC]

Doing fine, thanks

[@jaycevessier7554]

It’ll never stop hoping unless you do one of two things. Either trim tabs or more power. The bounce is because the boat is under powered

[@MarksAultimateRC]

May check into trim tabs, but the hop is minimal after trimming, need to get a speed meter into it to determine if it was actually going faster with a little more hop with the batteries back. Nacked eye test, seemed like it was

[@jaycevessier7554]

@@MarksAultimateRC I wouldn’t care if it was faster, I can’t deal with that hop. And I run a 50mm 3 blade, so I’m in the upper 60’s