Great video explaining the basic function and emulsification process!
@Adrenacyde7 ай бұрын
This helped A LOT, thank you! The whiteboard diagram made it easy to understand.
@hehworks89372 жыл бұрын
Rick, this video and your videos on the summit carb are extremely useful and well put together. Thank you for posting.
@berntsteinmetz8564 Жыл бұрын
the venturi effect would pull 4 times the fuel at double engine speed. the bleed air balances this down to double fuel at double speed.
@peggyparrow2059 Жыл бұрын
Thanks for helping me understand one more thing about carbs.!
@turboman85222 ай бұрын
best explanation thanks,better if also explained why we can adapt a bigger carby by tuning the air bleeds and emulsion holes
@mikecondoluci53 Жыл бұрын
GREAT VIDEO THANK YOU
@andrewsharpe3422 жыл бұрын
Jetting size for a L28 engine an emotion tubes to use to get performance
@COLLAR01Ай бұрын
Wow great info
@chrisspain777611 ай бұрын
I have a Weber which is running too lean when I am at full throttle, high engine speed, but too rich at light throttle. I just can seem to get enough fuel at the top end, unless I do something radical like block off the air jet, then of course its too rich at low speeds.
@ricksshop11 ай бұрын
Go down in idle jet size to fix the rich low speed issue, and up in main jet size to fix the lean condition.
@chrisspain777611 ай бұрын
@@ricksshop Tried lower idle jets and it doesnt work. I think the fuel is coming from the main orifice.
@ricksshop11 ай бұрын
@@chrisspain7776 check the air bleeds to make sure they are open, and float level...
@randywl89252 жыл бұрын
One more mystery solved..... .....or, ok, I won't mess with em. 😁
@MattsRageFitGarage Жыл бұрын
Have you ever removed the well tubes from a Holley metering block like the one shown? not quite sure how to get them out for cleaning without totally ruining them.
@ricksshop Жыл бұрын
Yes I have. Once you get the plug out of the top. You can drill and tap a shallow hole in the top of the tube (don't break through into the fuel passage) and suck it out with a screw and spacer
@MattsRageFitGarage Жыл бұрын
@@ricksshop I drilled and tapped the well tubes out of two carbs to 6-32 and threaded a screw into them. My home made vise grip slide hammer takes them out effortlessly damage free. Thanks!
@bobwhite4344 Жыл бұрын
nice vid.
@carlodonnell146 Жыл бұрын
Is a well tube the same as an emulsification tube?