How the idling circuit on a carburettor works and how to adjust it correctly
Пікірлер: 21
@tersiusnel69833 жыл бұрын
The correct way of getting your idle jet is to determine how many turns out your Mixture screw is , more than 2.5-3 turn out (then your jet is to lean/small) if it's less than 1-1.5 (then your idle jet is to big) That is the correct way , also take in consideration that you must also count your turns on the idling screw, more than 1.5 turns out then your Mixture is to small and your pulling fuel from your mains and other way around. This info is ONLY relevant if there are no vacuum leaks. Cool videos , hope my input helps
@carburettorrebuildservice89643 жыл бұрын
Thank you for the input, glad you like the video. thanks for watching.
@kyleventer1391 Жыл бұрын
where did u get the carburetor guide from?
@carburettorrebuildservice8964 Жыл бұрын
I saved a copy on my Facebook page, find Carbutettor rebuild service and look under files
@kyleventer1391 Жыл бұрын
@@carburettorrebuildservice8964 thanks 👌😁
@ally1433 Жыл бұрын
HI. could you perhaps assist with a contact place where one could purchase various jet sizes please. Thanks
@carburettorrebuildservice8964 Жыл бұрын
Hi, if you are in South Africa then Whatsapp 060 654 6966
@dwaynecoomber66102 жыл бұрын
Brilliant videos thank you so much keep up the Brilliant work
@carburettorrebuildservice89642 жыл бұрын
Glad you like them!
@markwilliams15764 ай бұрын
very informative video hope you do a lot more many thanks
@carburettorrebuildservice89644 ай бұрын
thanks for watching my videos.
@BurnseysRT2 жыл бұрын
Thank you for this video. I have a 318 Chrysler marine engine that I need to adjust the idle on. It stalled as I was leaving the dock and scared the daylights out of me.
@jonathandutoit2213 Жыл бұрын
Hi there, I have 1600 golf with 38 Weber and 276 cam. Car smokes and overfuels on idle throwing plugs dead. I have 135 main 185 air and 45 idle jets in. Why is it overfeuling on idle. Thanx for your videos they are great
@carburettorrebuildservice8964 Жыл бұрын
Turn the idle jets in all the way, the engine should die. now turn both out 1/4 at a time. please let me know how you get on.
@timsager61532 жыл бұрын
Please explain that a 32/36 has a primary side and secondary each with a different jet
@carburettorrebuildservice89642 жыл бұрын
correct, it usually has different jets, i have used the same size main jest on some cars with a smaller air correction on the secondary.
@yanz0112 жыл бұрын
May I ask where to look at when the idle affects when clutch+break is pressed?
@carburettorrebuildservice89642 жыл бұрын
Hi, i dint think it is a carb problem, perhaps check your thrust bearing.
@Manuqtix.Manuqtix2 жыл бұрын
Will your car idle and start without an idle mixer screw?