Chevrolet GMC 5.3 4.8 6.0 No Spark

[@Rustrevisit]

Just saved me a ton of money with this video!!! Thank you for posting!

[@AlbertGarabet-p5u]

aligator clip on the alternator and one on the black wire of the coil harness, but where do you plug the other two sides and if the ground where are those points?

[@AlbertGarabet-p5u]

my question is how do I connect to the ground 102 with the clip?

[@Wrenchin_boys]

Thanks this video helped me get my truck running again

[@AlbertGarabet-p5u]

does he connect to the ground (102) with clip and how?

[@johncarlberg4481]

Thanks u da man got me back on the road

[@richarddebethizy]

Fixed my truck thanks

[@hectorvaldillez1863]

I’ll be trying this

[@Ghost-tx5jf]

🎉🎉🎉🎉

[@AlbertGarabet-p5u]

quick question, from what I see one red wire is connected to the alternator 2nd red wire is connected to the coil harness, where are the other 2 black wires connected too? and if the ground, do I just connect it to the ground 102 bolt?

[@swiftWord]

The 2 black wires you say are actually 1 wire. I removed the insulation off a small section. Any location you want to add a ground or use an existing ground that is suitable will work.

[@AlbertGarabet-p5u]

@@swiftWord thank you for your response , I had the same exact issue crank no start. I checked the rails still squirts out gas , i added 4 o2 sensors a crank shaft sensor , fuel filter & tried the clips to the harness … still no start . Please help

[@Jonathan-x7s5c]

So what part do you change to fix this problem ?

[@swiftWord]

The entire engine harness. Or you can add the ground as shown in the video

[@AlbertGarabet-p5u]

@@swiftWord right, you added one to the coil harness (black wire) to the alternator. but where does the other side of the wire go to?

[@AlbertGarabet-p5u]

@@swiftWord my question is how do I connect to the ground (102) with the clip?