Clone Rifles Shoot 2024 Montage

[@beach_ballistics]

Noooo that’s a C7A1!!! Had a great time man. Looking forward to next one!

[@InferiorRifles]

@@beach_ballistics Canada isn’t real so it’s ok

[@marcossanchez7578]

That's me with the MRE @5:24 and 1.5 @13:31. Cheers!

[@DowntownDeuce2]

07:05 the amount of gas coming out of the receiver/ bcg on the Gary Gordon Carbine is insane!

[@aown]

What do you think the problem is? Is that dangerous?

[@DowntownDeuce2]

@@aown No, it is not acutely dangerous. The suppressor adds gas pressure by keeping the gases trapped behind the bullet for longer than without the suppressor. This causes the cycling of the bolt carrier group to speed up, ejecting the casings harder and slamming the bolt carrier against the buffer tube. You can tell because it's throwing the brass forward, to the 1:00 position, instead of rearward at 5:00 position (if you were looking at it from above). If they went to a smaller gas port, to lower the gas pressure, it may not cycle reliably without the suppressor. If you want to be able to use the gun with and without suppressor, you have to make sure there is enough gas to cycle without the suppressor. The problem is when you put the suppressor on, gas pressure goes up. An adjustable gas block would solve the problem, but it is not practical on a military item. On a duty gun it's better to have a gun that is over-gassed with a suppressor, than to be under-gassed without it. It won't hurt anyone, put the increased pressure and cycling speed increases recoil and wear on moving parts.

[@DowntownDeuce2]

@@aown Not dangerous, just over-gassed because of the additional pressure trapped by the suppressor. There's a much longer dwell time created by the baffles and additional length of the suppressor, compared to muzzle only being a few inches past the gas port, which allows the pressure to bleed very quickly when the bullet exits the muzzle. It poses no hazard, but the higher cycling speed increases recoil because the bolt carrier runs out of travel space (striking the back of the buffer tube after the buffer spring is compressed totally). It's a more violent extraction/ ejection, causing the cases to be ejected forward instead of rearward. Ideally, it should eject at 3:00 or 4:00 position, instead of 1:00, like in the video. A smaller gas would prevent this, but it would not maintain reliability when the suppressor is not attached. It's better to be over-gassed than under-gassed, especially on a life safety application. The worst that could happen is wearing out parts a little faster.

[@aown]

@@DowntownDeuce2 Makes sense, thank you for the rundown!

[@brandonking9780]

Looks like it was a great time for sure. Some very very awesome guns too

[@xxxxxx-l4h]

13:22 its the a1 model of the C7, if it was the A2, it would have the adjustable stock in green and the pistol grip / hanguards would also be green as well. Also the A2 runs an ambi safety

[@thebattlefieldhistorian8990]

Great event! Looking forward to the next one.

[@See-yw1vw]

So cool wish I could have made it out there!

[@GoontubeActual]

Totally can't wait for next year! The people were amazing, and the prizes were awesome, too.

[@PS-cc4hm]

That Famas 😩

[@CKxx]

Hey, I made the cut 😂. Awesome time out there!

[@DowntownDeuce2]

Which is yours?

[@URMAGURDITSDAN]

Same I was shooting at 5:44

[@CKxx]

​@@DowntownDeuce2 I was shooting the RPD down on the right end of the range.

[@DowntownDeuce2]

@@CKxx That is one of the few Soviet Bloc items that I've yet to tackle. Did you purchase an assembled or build your own from parts?

[@earlmorrison8163]

Nice !! Thanks for sharing !!

[@armorers_wrench]

That looked like fun. You guys brought some really cool guns to this party. If ya'll have this at BFR again next year I'ma have to make a trip.

[@RedX-sx6ml]

I didn't even notice you there as I was talking about spam cans 😂

[@fresh-dad-of-bel-air2270]

Man, I wanted to go. I only found out a week before hand about it and that it was in Pennsylvania

[@Lucysdad66]

Sure look like alot of fun..

[@makevelicustoms]

Wow it looked so fkn cool 👍🏻 it looks like it’s getting better and better every year.

[@totenfurwotan4478]

Ryan’s done a good job with this range

[@srtallday3655]

Chandler gang 💯

[@Otterweaponworx]

Low blow Chris….hahahaha I’m sorry I’m moving

[@InferiorRifles]

@@Otterweaponworx 😂 we all missed you there man!

[@cagneybillingsley2165]

why is the only person who can properly cycle a bolt action there a teenage girl at 15:04? lol

[@InferiorRifles]

Definitely not a teenager, but she did have good fundamentals. Thanks for watching

[@Annoyingdog37]

why did that eotech look like it was reciprocating with the recoil?

[@URMAGURDITSDAN]

My Eotech got loose when shooting earlier

[@URMAGURDITSDAN]

I’ll have to tighten it down more

[@idra-j5y]

13:32 🔥

[@marcossanchez7578]

Cheers! That's me!

[@theLeadGin]

Damn, the only one that didnt look awkward like it was their first time was the chick running the AX like champ! Hats off to her the rest of ya'll should be embarrassed 😂

[@InferiorRifles]

To be fair, for the majority of the folks in this video it was probably their first time firing the gun they’re holding

[@Lucysdad66]

I thought averybody looked perty personal for a bunch of hillbillies.

[@SuperVonKiller]

Man! No footage of that suppressed M1 carbine?

[@southern_firearms]

Hopefully I can make the next one!

[@Jonny-tr9qo]

Nice

[@StilettoCraft]

For one of your next builds you should clone a Knights SR47.

[@sethmarkowitz6660]

0:45 what in God's name is the rifle second from bottom? That is the weirdest stock mod I've ever seen.

[@cc5855]

Pick up the brass wtf lol oh naw

[@InferiorRifles]

God forbid everyone pitches in a little to help the range staff who worked all weekend while we had fun

[@noneyabidness196]

The levels of cringe you have to overlook to come to a clone shoot dressed like that @6:10 😂

[@LRRPFco52]

It's perfect! Everyone should come in some period-correct ensemble and have contests with that too.

[@Rambo564352]

Hey don't speak about our airsoft lord Greg "LARP" Wong like that.

[@LRRPFco52]

@@noneyabidness196 I wanna see nothing but ERDL, legit Tiger Stripes, Woodland BDUs, Chocolate Chip Deserts, Night Desert, and Tri-Color DCUs. People need FLAIR!