CNC LATHE PROGRAMMING EXERCISE 1

[@alphaindustrieprodukteltd6057]

I appreciate your teaching lessons sir. Actually I have some metric system questions but I think I can handle these by watching again your videos. Many tnx Tom. Chris

[@ALUMATRIX]

another very helpful video,, i always learn something,, keep'em coming

[@mousongie]

Thanks very much Tom! Always doing great job. Keep it up, Sir!

[@TomStikkelman]

mousongie mousongie Thanks Mousongie.

[@feliexhiruthayasamy109]

thanks sir. this video is very useful. i always watch your video.

[@TomStikkelman]

Feliex Hiruthayasamy Thanks Feliex.

[@anilvarma808]

Thank you very much...😀

[@paulkennedy5953]

How do I set another work shift in order to flip the part to face and turn the second side.

[@nguyenvu9248]

thanks very much Tom .it is very easy and clealy to understand when u explain .I hope U Post more lathe video for us ,very helpful .are you write cnc book sir?

[@TomStikkelman]

Thank you for that feedback nguyen vu. Yes I am working on a book but it will be a while yet before it will be released. More videos to come about lathe programming. Thanks. Tom

[@imamkhanimamkhans7886]

Thanks very very

[@ReyBanYAHUAH]

Always remember to repent of your sins (sin is transgression of YAHUAH’S LAW: Genesis, Exodus, Leviticus, Numbers, & Deuteronomy) And Have Belief On YAHUSHA HAMASHYACH. HE Died and Rose three days later so that you can be forgiven of your sins! HE Loves you! Come to HIM!🙂

[@jarisipilainen3875]

0.35 it so easy part no need CAM, but unprofessional drawing. what is angle of that big chamber. i need that for calculate compensation. for start i would need calculate that andge. ok its 15.0053 degrees,but why? would it be easier just tell its 15degrees than give dimensions? why 1.998 not 2? and why 1.099 not 1.1 od 1.5 0.748x15degree if thats what looking for 1.099 is programmer nightmare and undeeded. that number is actually i BELIEVE becouse its 1.09914 and its rounded 1.099 if that is 15degree and. becouse these values it would not be 15 degree. i would do it exatcly like its drawed,but dont know maybe this is how they do it america LOL if it 15 degree forget 1.099 becouse if i know its 15 degree i allready know where tool need be on od1.5 on that 1.998 dimesion. i allready know without calculating lol without need cam or G42 magic top secret code is (1-tan[angle/2])*TNR that would be added 1.998 .BEATS G42 and CAM i remember all compensation numbers for tool noses 0.2-1.6 for angle 15.30.45.75 . the most used angles. then it all bout. we had battle CAM seler versus cnc programmer. i made program 100% CAM measures. rule was not use G42 need calculate tool path. i made program faster than seller draw picture and started pushled how generate tool path LOL. i could hit cycle run and go coffe and help that seller pack his stuff we not need CAM. short story but true lol