Concrete Leveling with Straight Edge for Laminate Cork Flooring Installation

[@MrYoucandoityourself]

Hello my friends! I just share my last small project about how to make a concrete floor leveling with straight edge for a cork flooring installation. So, my next video will be about a cork flooring installation. Don't miss it!

[@frd3fadi]

Luck customer to have you . Thanks boss .

[@MrYoucandoityourself]

Thanks for your commenting.

[@christcrucified6385]

Doesn't the leveling compound require a minimum of 1/8 in thick? I was thinking of doing it like this but I can't find a compound that will allow it to go so thin? It looks like you are simply filling in any low spots by dragging a straight edge across the floor. That would leave a lot of places under an eighth of an inch thick.

[@MrYoucandoityourself]

Hi, requirements depend what components in this compound. For example, Ardex have a very small parts and can be used for almost zero thick.

[@christcrucified6385]

@@MrYoucandoityourself Thanks I will check it out

[@Bf3xx]

How long is your straight edge?

[@MrYoucandoityourself]

This straight edge 10 fits, also I used 8 and 6 fit for a small area.

[@jrtjohn1]

another great video my friend

[@MrYoucandoityourself]

Thank you very much, my friend!

[@SyberPrepper]

Very interesting how you can go over some flooring materials. Also, it's good to know that your grinder doesn't kick up a lot of dust thanks to your cyclone and HEPA vacumn. Thanks for the video.

[@Muscle65car]

I seen in the past you use novoplan plus, which I have used too but yours pours much thinner and drys a lot slower. Direction shows 5 to 5.28 quarts/50lbs and sets in about 10 minutes or less. What do you use for mixing ratios?

[@MrYoucandoityourself]

Put little bit more water.

[@Muscle65car]

MrYoucandoityourself thank you for the quick reply. Just judge by the consistency of the mix.

[@MrYoucandoityourself]

Good luck with your project!

[@Technologyadvisor1]

Hello I have laid leveling compound on a garage floor but I have not used enough and the compound I have put down needs to be raised a few mm as I have not used enough. Can I top it up? it has only been put down 24 hours but I need the level to be level with some concrete that goes round the sides of the garage. please help

[@jashby9736]

probably have to wait for it to dry thoroughly and bond and level on top.

[@abusydayinremodeling2720]

Скажи пожалуйста на какую камеру снимаешь.??

[@MrYoucandoityourself]

Sony Cyber-shot - amzn.to/2S88OE8

[@abusydayinremodeling2720]

Всё супер, только береги руки, опирался на ладони.

[@MrYoucandoityourself]

Прям как в кино: "Береги руку, Сеня!". Спасибо, Серега, за заботу!

[@abusydayinremodeling2720]

У меня тоже есть несколько видео можешь глянуть Если интересует

[@MrYoucandoityourself]

Хорошо

[@vsenikizabity]

Там всё равно будет стоять кровать)))

[@MrYoucandoityourself]

Все равно - будет на клладбище, а все остальное нужно делать наилучшим образом. Я так понимаю.