Connecting rod and piston rings Installation / Repair honda lawn mower

Installation direction for the connecting rod to piston ( honda lawn mower hru216 / hru169 ).
Repair Small engine / 4stroke gasoline small engine
Install the piston rings in a typical way to ensure Tension washers installed incorrectly, huge gap between the bottom of the crank and the blade disc surface, no impact wrench or torque wrench used to install the disc, mower tipped the wrong way.
Why would they even make this video? notes that interest you. Some notes on installing piston rings from the spaces between each ring and the direction of the rings
The video shows the correct way to install the piston inside the engine.
I will be happy to subscribe to my channel and wait for your comment
• Piston & Rings l How t...
• Restoration Old engine...
• Piston Rings Installat...
Paano Mag-install ng Mga Piston Ring
Hur man installerar kolvringar
Comment installer les segments de piston
पिस्टन के छल्ले कैसे स्थापित करें
#Handicraft
How To Restoration Brush Cutter : • Restoration Brush Cutt...
How To Power Sprayer Pump Repairing : • Restoration Power Spra...
How To Repair the Carburetor : • How to Repair the Carb...
How to repair pull starter : • How to repair pull sta...
#reparing_show #piston_rings #small_engine
Thank you
Ahmed Adel.
Juice by tubebackr | / tubebackr
Music promoted by www.free-stock...
Attribution-NoDerivs 3.0 Unported (CC BY-ND 3.0)
creativecommon...

[@andrewpettey9243]

Never seen a more informative and thorough video where a word was never spoken

[@RepairingShow]

This comment is not strong support for me. Thank you for supporting me 💚

[@KimudubalakrishnaKimudu]

బయ్య రింగ్స్ పెట్టడం ఓకే but అర్దం కాలేదు.

[@RepairingShow]

Thanks for your comment

[@icarossavvides2641]

1) If he's repairing a HONDA lawnmower why does the piston have YAMAHA written on it? 2) he points out the engraving on the pistons rings, but why????

[@RepairingShow]

Welcome and thank you for your comment. The piston ring marks should be facing up. and the piston conforms to specifications

[@infotech1317]

I think wrong placement of rings