Got a scrap tyre machine thats flood damaged so decided to rebuild it on the cheap, only cost £40 for bearings and a seal. Jobs a good-en.
Пікірлер: 26
@maxheadroom2243 ай бұрын
Currently troubleshooting a leaky fitting maybe from the bead blaster. The nimrod who owned the machine before me had the capacitor in the bottom zip-tied to the top of the motor so it got wedged in- between the belt.
@CarJunkeez3 ай бұрын
It’s amazing at how bad condition these things get in isn’t it mate 😂 and some previous bodge jobs make it difficult to rebuild them but once done they’re a really good machine 👍 good luck with yours mate 👍 cheers
@rustandoil5 ай бұрын
The cash i could have saved over the years by having one of these! .... Just a bit jealous 😊
@CarJunkeez5 ай бұрын
Me too mate, I should of got one years ago 😂 and a lot tyre places don’t do a good job anyway so you need to do it again
@mattjones72002 жыл бұрын
Nice to see a new video👍 came up great pal.
@CarJunkeez2 жыл бұрын
Thanks Matt, appreciated as usual mate 👍
@GavincredibleAU22 жыл бұрын
Great job, it came up nice 👍
@CarJunkeez2 жыл бұрын
Thanks mate, appreciated 👍
@theresahoffman840824 күн бұрын
What lube did you use on the small cylinder? Or was that just soap detergent?
@CarJunkeez24 күн бұрын
Hi, yes that’s correct it’s just soap detergent (washing up liquid) 👍 thanks
@mdkrocks97 Жыл бұрын
Nice work!
@CarJunkeez Жыл бұрын
Thanks mate 😃👍
@nushooz6731 Жыл бұрын
Did you need to give the turntable a few wacks to release it.
@CarJunkeez Жыл бұрын
Certainly did mate but wasn’t as bad as I thought it was gonna be after I seen all the crap where the nut was 😂
@nushooz6731 Жыл бұрын
@@CarJunkeez I've undone the bolt gave mine a few wacks with a large nylon hammer but it looks like it doesn't want to budge.
@CarJunkeez Жыл бұрын
@@nushooz6731 have you give it a good soaking in penetrating oil and leave overnight, if it still doesn’t budge give a little heat carefully with a blow lamp, I know it’s awkward to do so though 😂
@nushooz6731 Жыл бұрын
@@CarJunkeez I will give that a go thanks for advice.
@CarJunkeez Жыл бұрын
@@nushooz6731 also if you leave the bolt in just undone a little and have a block and chain lifting the turntable up so you’ve got the weight hanging then hit the head of the bolt with a hammer and wide punch, that worked for me mate 👍
@miffrhys49002 жыл бұрын
Brilliant.
@CarJunkeez2 жыл бұрын
Thanks mate 👍
@jdys8525 Жыл бұрын
Hi. My Corghi machine needs a full service + seals. Would you do it for £?
@CarJunkeez Жыл бұрын
Hi, sorry I’m far to busy with work, I don’t even get chance to do my own projects lately 😂 cheers 👍