Coyote Swap New Edge #4 - Prepping & Installing The Engine (PBH Brackets, Headers, Flywheel, Etc.)

[@jfisher99999]

Excellent info here, thanks!

[@MillennialDad92]

Glad I can help. Control pack and video with ALL wiring was filmed yesterday. Should be posted soon.

[@mustangjoe5048]

I’m using a Gen3 with a TR3650 basically same as you’re T45. My question is what flywheel did you use. I assume you just used the 10 splin 11” clutch.

[@MillennialDad92]

McLeod lightened steel flywheel

[@devaunteturner4541]

I am planning on doing a coyote swap on my 1999 mustang but I had a question. For the UPR K-member what rack bushing option did you pick to keep using the stock rack and pinion because they have offset and standard I just don't want to buy the wrong one?

[@MillennialDad92]

I used regular bushings that came with the k member. They sent two sets. A racing set (red) and a street set (black) non offset

[@fordracing5oh]

Do the coyote takes the stock 4.6l fly wheel “ BOLTS”

[@MillennialDad92]

Yes the 4.6 flywheel bolts will fit in the coyote however I suggest ordering new bolts from ford. They’re only 10-15 bucks. I also have 3 extra sets in my garage because I always buy new ones and hoard the old bolts lol

[@Keasbeysknight]

I just did my bbk lth on my 97 cobra for the second time and i used a combination of the bbk bolts and the factory studs. Fitment was a bitch and there is definitely an order of operations to it. Glad to see the progress! Its getting close!

[@MillennialDad92]

I’ve been wanting to put headers on my cobra because my manifold bolts are rusted pretty badly but I’ve held back because I’m worried they will snap off when I go to remove them.

[@Keasbeysknight]

@@MillennialDad92 yeah.... This is why I now have the egr deleted and the other emissions start up one that's connected to the headers.... Which leads me to now forging my block because if I'm gonna tune it again, I might as well do it with more boost ;)

[@MillennialDad92]

@@Keasbeysknight this winter I’m putting a kenne bell on it and a full exhaust system I’m just dreading the thought of having to extract broken manifold bolts out of my teksid block lol I’m thinking about just getting shorty headers because I already drag sometimes and I know long tubes will be even lower lol

[@jfisher99999]

What gen engine are you using? Sorry if I missed it

[@MillennialDad92]

Engine was pulled from a 2015 Mustang GT. Gen 2