CREALITY CR10S PRO V2 VASE PRINTS CURA DEFAULT SETTINGS
Пікірлер: 16
@irina53732 жыл бұрын
Hello. Good work!!!! To print this model, it's need about 40 hours. Maybe you know how to print this model by parts for 8 hours in a day, for example. Because my 3d printer at work and I can't leave it to work all day and night.
@CzK.2 жыл бұрын
Hi Yes you can print it by parts, using printing resume option but in this Case when finished print, some line track will be shown. on the model.also parts colors maybe seen different.So if possible for clean print please dont print model using resume option (by part) but this is your choice.Good Luck.
@irina53732 жыл бұрын
@@CzK. Thank you for the answer. Ok, I need to print a model to make a silicone mold.
@alfredogranados1124 жыл бұрын
Hi, good job. A question: What brand of filament did you use for these pieces?
@CzK.4 жыл бұрын
Hi.I used Esun PLA Filament.Temperature settings are 200 degree hotend and 55 degree for heatbed.
@haif3213 жыл бұрын
How much time did it take to print...and the slicer settings...
@grahamserle79304 жыл бұрын
Nice job. I've just purchase one, can you send me a link for where you purchased the magnetic mat and plate. I'm having trouble finding one. Cheers
@CzK.4 жыл бұрын
Hi.I purchased it from my local shop but yes difficult to find it and expensive.I advise glass bed or wham bam system(whambamsystems.com)
@grahamserle79304 жыл бұрын
@@CzK. Is that because the stick on adhesive bed lifts with the higher bed temperatures?
@CzK.4 жыл бұрын
@@grahamserle7930 Yes it lifts with the higher bed temperatures, this is my third magnetic bed in 6 months so glass bed and PEI or wham bam system seem good solution.
@edlemes26313 жыл бұрын
Hello, are you satisfied with the printer because I'm planning to buy the same.
@CzK.3 жыл бұрын
Hi. It is good quality, works well.I recommed v2 version(with bltouch).
@alejandrorios20593 жыл бұрын
Hello, would you have the settings and what software do you use for the machine? I have the same and I use simplify3d or cure, could you tell me the configuration files
@CzK.3 жыл бұрын
Hi I used default settings and Cura.Pla filament, 20% infill, 200 degree, 60% speed.