Custom heat coil mounts for powder coating oven.

[@ebencooley4797]

I hope you go into detail with the wiring of the PID controller. I have a homemade oven fully constructed. I gutted a traditional electric oven and used that wiring harness for my build, unfortunately though I didn’t test it beforehand like an idiot and I found out that the controller was not functional. So now I am investigating the PID option but I feared that it may be a bit of a headache, and I wasn’t sure if it would work for my application. Seeing that someone else is using the same methods gives me some inspiration that it may work…

[@welding2go]

Hey good morning I definitely will be going into detail. In the meantime, if you would like message me on Instagram and I’ll send you a wiring diagram and see if that can help you out.

[@jamesthorn3887]

would really love a list of control box parts and wiring diagram. Great Videos!!

[@welding2go]

Thanks Jim, message me on Instagram and I will send you a diagram. I will also send some links on what I used on this build.

[@welding2go]

a.co/d/fI3ug52, a.co/d/0WC102E, a.co/d/bwtLy0h,a.co/d/eEnpPmG Hope that helps, cheers!

[@978Scooter]

A True Canadian right there.. always gotta have our Timmies handy!! ☺️

[@welding2go]

💯🇨🇦

[@gbodyperformance]

What is the watts of your elements and where did you get them?

[@welding2go]

Hey good morning, the elements are 3000 W each to run both elements you would require a minimum 40 amp service. I have an account with a supplier, but you can buy something similar on Amazon.

[@gbodyperformance]

@@welding2go ok thanks. I was hoping that you would have a link but I will search.

[@welding2go]

@@gbodyperformance I’ll send you one

[@welding2go]

a.co/d/2E6LkMu Hope that helps

[@markpinkstaff2287]

Looks good but I just used single gang electrical boxes….

[@welding2go]

That works 👍🏼