Cutting Bend Lines - Fusion 360 - Langmuir CrossFire Plasma Table

Short video showing the way I setup my cut paths for bend lines.

[@1320freek]

Thanks for taking the time to make this video and share it!! Much appreciated!!!

[@MohawkDaveOffRoad]

You just saved me hours of headaches, Thank you and Subscribed .

[@zachhoyt92]

I've been hunting this information all morning and here it is finally! Thank you sir

[@Zfrostyone]

This was a great help to me. I followed you instructions and everything worked as it should. You have saved me hours of research. It is much appreciated! Thank you for taking your time to do the video.

[@jojobarwick]

Only works if it is a 2d component. If you want to do this from a component out of a design that is a flat pattern. The sketch lines don’t follow the profile.

[@jonbozzy9600]

Thanks so much!!!! This help me so much

[@yesenlirkad]

Thank you!

[@p.t.anderson1593]

I have a CF Pro. This was very helpful. Thank you so much. How did you get Fusion360 to have a grey background?

[@TheRoundFAB]

Enjoyed the video, very informative! Can you do a video showing how you set up for parts that have fine detail. Specifically lead ins and leads outs?

[@theincompetentcraftsman]

I will see what I can do!

[@williamvaughn9870]

you said you added Z-axis, what does that involve? Did you order it from langmuir systems?

[@theincompetentcraftsman]

Check out the Langmuir Crossfire forums. There are several of us that have added a Z axis to our Crossfire tables.