How to Replace Saab 9-3 Door Mirror | WITHOUT Removing Door Casing

How YOU can replace Saab 9-3 door mirror | SAAB 9-3ss, SAAB 9-5 & SAAB 9-3X, 03MY on
Change mirror Saab 9-3 | replace Saab 9-5 mirror
📽 Saab door mirror glass replacement: • Saab Side Mirror Glass...
Solve water leaks, wind noise, breakages, corrosion
💡 Don't forget to subscribe and hit that bell 🔔 to learn more about looking after your car:
kzbin.info/door/-C_1iVg...
💚 If you got some VALUE from this video, PLEASE give it a ‘like’ and maybe consider showing your appreciation by buying me a coffee: paypal.me/cyclonecyd
🎥 Saab 9-3 mirror cover & motor removal
• Saab 9-3 Mirror Cover ...
🎥 Saab 9-3 side mirror glass replacement
• Saab Side Mirror Glass...
TOOLS:
Torx key set
bit.ly/Torx_key_set
Torx bit set
bit.ly/Torx_bit_set
Size 6mm ratchet spanner is hard to get, but available from here
bit.ly/Ratchet_Spanners
🎥 How to remove & replace the rear lights and bulbs on your Saab 9-3:
• Saab 9-3 tail light bu...
🎥 How to reset your Saab’s “time for service” message yourself:
• Time For Service Saab ...
🎥 Why not explore my entire Saab 9-3 playlist:
• You CAN Service Your S...
🎥 Crank sensor failure is such a common issue. Learn to recognise the symptoms:
• CRANK Position Sensor ...
Sealant applicator gun:
bit.ly/Applicator_gun
Spare nozzles for your sealant tubes:
bit.ly/spare_nozzles
Leak sealing duct tape
bit.ly/Leak_seal_tape
Dummy shark fin in case yours is looking tired:
bit.ly/dummy_fin
Learn more about looking after your car:
🎥 How to replace a CV [constant velocity] joint boot with a split kit:
• Universal CV Boot Repa...
🎥 Don’t let your fuel filter end up like this:
• Why Should I Change My...
Everyone should have a tyre pressure gauge in their glovebox:
bit.ly/Tyre_press_guage
bit.ly/Pressure_Gauge_2
I personally prefer a stirrup pump to a foot pump (I use the same one for my bikes and cars)
bit.ly/Tyre_stirrup_pump
If you’d like to learn about the science and engineering of cars:
Bosch Automotive Handbook:
amzn.to/39va9xA
Thank you

[@CycloneCyd]

📽 Saab door mirror glass replacement: kzbin.info/www/bejne/mHapkn6Hf7tqrNk

[@DobbsyLondon]

New saab owner (new to me) and VERY new to car servicing and maintenance at any level higher than a first parade of a vehicle 😅 got my Haynes manual amd some decent tool from other stuff, but your videos are a massive help. Thank you.

[@CycloneCyd]

Welcome aboard! Decent tools are a must. I try to list all the tools needed within the videos. So watch carefully and note down anything you need but haven't got - there's links in descriptions to help you too. Once you have the basics, buy what you need when you need it. Think of them as part of the cost of the job and think about how much cheaper the tools are than labour at a garage. Consider joining "Saab 9-3 (2003-2012)" on Facebook. A great group (of course it is, I'm in it 😂). And you can always ask for advice here too, but hopefully my videos answer most of your questions.

[@DobbsyLondon]

@Cyclone Cyd thank you kindly, already all over that group like white on rice ;)

[@andyaclean]

thank you so much got a Saab 93 vert last week and I'm loving it but I have a few small jobs to do and your channel has been great MANY THANKS

[@CycloneCyd]

👍

[@StuK323]

Really helpful video, saved me having to pay a garage to do it.

[@RagnarTheRed1]

Huh, this is gonna speed things up significantly whenever I get to painting the side mirror base. Thank you!

[@CycloneCyd]

Happy to help. Yeah, every other instruction I can find says to remove the door trim. Which itself, is a pain in the arris!! I'll be doing a full refurb soon, with a few more tricks up my sleeve, but right now I'm finding it hard to get the bits needed, so it'll have to wait till we get back to normal "normal"? what is that? Can someone remind me? lol lol lol lol lol

[@RagnarTheRed1]

@@CycloneCyd Yes, exactly! That's the reason I haven't done that yet, haha. Oh, might be worth waiting for that video then. Some extra tips and tricks won't hurt.

[@JoseLuis-bg8nt]

Thank you for your Saab videos

[@ddog4608]

Cyd The Legend saving me money again!

[@martindavis9212]

wonderful Cyd just done exactly what you advised ! many thx

[@timthorne3412]

Well done a great Video...explained everything in detail confident i can remove mirror now the easy way Thanks

[@olofmeister5779]

Great and informative video!

[@eziux]

Just what I needed, planning to repair the aluminium shield corrosion soon which is very common on these.

[@CycloneCyd]

It's common on loads and loads of cars. You'll need to watch this then: kzbin.info/www/bejne/ZoXMnGmpZ9CFqJY

[@shawshankkid]

Nice Cyd. All good to know just in case. Keep up the good work.

[@CycloneCyd]

Thanks, I'll try 🤘🤘

[@Nukerduker]

If you have the tilt/parking function is it possible to change the mirror into automatic folding ones? I have the one with memory + the tilt/parking function but was wondering if its just as simple as switching the control module or do you need to switch the mirrors as well? Do you have to change the harness as well or is it possible that the harness inside already has the wires it needs?

[@spandaubilly]

Spot on 😎

[@samwu8070]

Very nice and detailed explanation and procedure

[@CycloneCyd]

Even WIS tells us to take the door casing off. I knew there had to be a better way 👍👍💡💡

[@ryanvoros3131]

good video! thanks!

[@CycloneCyd]

Glad it helped!

[@mohannadsharrouf]

Leuk man!

[@sw2599]

Legend

[@shantaram3726]

Hey, thank you for this great video. I have one Question, will this also work with the Saab 9-3 YS3F Cabrio?

[@CycloneCyd]

I imagine it would, but cannot be certain as I don't have access to a vert to try it. Do let us know how you get on

[@lspd5916]

My folding mirror motor dosnt stop and keeps going until the mirror cover is facing the windshield. A quick fix would be to pull out the connector seen in the video? Downside would the that you cant adjust the mirror anymore (beside doing it manually). Right?

[@CycloneCyd]

Yes and yes

[@ftby59mikeD]

Magnets are your friend when working with fasteners that once removed are prone to fall in areas where they can't be retrieved.👍

[@CycloneCyd]

They are indeed, but no method is infallible.

[@kermitthefro]

I've recently replaced my door mirror and your instructions did wonders, but now I get a lot more road noise inside. The mirror sealed perfectly, so I'm not sure why. I see you have some noise deadening material applied, maybe that's related?

[@CycloneCyd]

Door mirrors are a nightmare for wind noise, but not usually road noise. If you bought a 2ndhand mirror I would suggest removing the big rubber seal and fitting your original one instead. They shape to the door and it only takes pin prick gaps to let in noise. Also seal the gasket to both the mirror and door. Also stuff some Dacron or felt into the triangle the mirror fits to (or fill with a little expanding foam).

[@fredericlopes2533]

Bonjour,j'ai mon rétroviseur gauche qui ne se rabat plus, faut il le changer par un autre,ou est il réparable s'il vous plaît ? Cordialement

[@kentb3175]

Whats is the extra piece of foam on the dashboard side covers? Is it for sound deadening?

[@CycloneCyd]

Yes, it is. You'd be surprised how much road noise it cuts out. I'm going to be doing a mini series on 9-3SS NVH later in the year. Mine is 2dB quieter than a Velar at 70mph!!

[@kentb3175]

@@CycloneCyd I did the inside of mine with a sliver backed adhesive foam deadening as well as the door cards, makes a big difference. I also placed a bit of the foam over the aperture for the window switches as the draft from them is quite considerable, stopped it completely.

[@benwilson9017]

Hi Cyd i know this is unrelated to the video but could you please do a video to do with the common problem with 93s high beam stalk not working or been intermittent please? As always great video highly appreciated 👍

[@goodcitizen3910]

Same issue here

[@goodcitizen3910]

B206

[@benwilson9017]

I ended up bypassing it with a switch

[@colinparks619]

How do. I get the cap off the back without breaking the glass!!

[@CycloneCyd]

Ah ha! Take the glass off first: kzbin.info/www/bejne/mHapkn6Hf7tqrNk Then you follow this: kzbin.info/www/bejne/ZoXMnGmpZ9CFqJY Watch both and it should become clear. If not, ask.

[@adeliepedro3661]

9-3side mirror

[@-Luksu-]

I painted my mirror bases and didn't bother putting the last screw on and they feel sturdy enough

[@CycloneCyd]

Even if you cannot see it or hear it, it will vibrate in response to road inputs and will eventually break. The three fixings are like a tripod providing a sturdy base.

[@-Luksu-]

@@CycloneCyd It was a pain in the ass but I removed the door panels and put the last screws on