DeLorean Industries Spec 1 Exhaust Install

[@danieldean7123]

Awesome vid. Incredibly thorough. Still have a few questions: -Why didn't you remove the axle to make getting to the bolts on the driver's side end of the crossover easier? -Which side of the muffler goes up? Does it matter? -It doesn't look like you're reusing the big stock support brackets. Are they omitted? Muffler is floating? -There's enough room to access frontmost studs? Access from in front of engine cradle? Sorry for all the qs! Thank you!!

[@RonVelvet]

Sweeeeet🔥🔥

[@george8757]

I have the same exhaust set up on my 83 for four years, it’s been great so far and you notice the bump in power and torque. Best header/exhaust combo on the market for a Delorean!!

[@MrRiddler6789]

Hello, I am located in So Cal I just bought a Delorean Industries exhaust for my stage 2 that was done in 02. I am looking forward to the video! Just subscribed

[@DeLoreanDestiny]

Thank you!

[@bricepalustran9204]

Hello, have you ever had problem with heat? Hot pipe are so near from oil filter and starter solenoid. Thank you

[@DeLoreanDestiny]

No problem. But something I forgot to mention in the video was that I wrapped the starter/alternator wiring harness with a heat wrap shield to protect against heat. Maybe I'll make a video about it.

[@bigsarge2085]

👍

[@michaelholliday100]

You have bad engine mounts... They need replacing...

[@DeLoreanDestiny]

They have been replaced but thanks for noticing.