Delta/Ammco Metal Shaper - Machining Model Hit Miss Engine Base

[@zoltannagy1813]

What was the purpose for the strip of paper between the job and the angle plate?

[@ianrenshaw6653]

@@zoltannagy1813 Hi, thanks for the question. I had filed the base the best I could but felt that the casting could be a little bigger on that side so I put some paper packing under the low side. I did not film it but I mentioned that I would be machining the vertical edge and will later use that edge to machine the base to clean up the inaccuracy. I hope this clarifies the packing.

[@zoltannagy1813]

@@ianrenshaw6653 Thanks. I wasn't aware that it wasn't machined yet. Now it makes sense.