Destiny 2 - "For The King" Thorn Replica

Printed on an Ender 5 S1
Print time 40 hours
Filament use 290g
Acrylic paint used plus a spray of fine lacquer
Free model here: www.printables.com/model/2093...
00:00 Introduction & setting up the print
01:16 Printing out parts
01:59 All the parts & assembly
07:30 First full coat of paint
08:24 The finished Thorn with For The King
#destiny2 #cosplay #3d #3dprinting #3dprint

[@Kalbo64]

If you have any questions please feel free to ask them in the comments and I will do my best to answer.

[@WorldlywarcraftDK]

Just found the channel and the video but like the style as i dont know much about 3d printing but it looks cool!

[@Kalbo64]

Thank you :D

[@stickkytape]

Hey Chris, what did you use for the spring? the instructions say a spring from a Bic? pen but far as I can tell that would keep the trigger in the pulled position

[@Kalbo64]

@@stickkytape Hi, I have a small box of mixed springs I purchased from Amazon if I remember correctly. I show the spring position here - kzbin.info/www/bejne/bICrlIOpjceJiMk if that helps. Good luck with the print, hope it turns out great :D

[@NkySpike65]

Looks Great!

[@Kalbo64]

Thanks!

[@theenderclops]

now i really wish i had a printer.

[@kennybulow3183]

Are you the one who modelled it and thingsverse/printables? Or just a printer guy :) I noticed almost all the pieces don't lay flat on bed/are skewed in they cuts. What did you do to that ?

[@Kalbo64]

Hi, It isn't my model I just printed it. The only parts I found don't quite lay flat to print were the two sided to the chamber and trigger parts. I just used support to level it out, and found it easy to trim off after printing.

[@asianmiIk]

What did you use to paint it

[@Kalbo64]

Hi, I used acrylic paints with a plastic primer.

[@NickJ342]

what scale are all the parts at?

[@Kalbo64]

Hi, it's 120%

[@NickJ342]

@@Kalbo64 thanks👌