Dieselmeken show MAS100 membran swap Lucas DPC pump

This is a small clip how to swap membran in the boost compensator on older Citroen 2,5L Turbodiesel pumps. MAS100. It can be done while the pump is still on the engine.

[@stonecold9347]

thank you . i guess this will also work on a 1.8 td lucas ford pump ? it s leaking fuel ...starts good , pulls good ... maybe the o-ring on the cap u taked out first ?

[@Farseer1995]

Great video, so there isn't any adjusting that has to be done, correct? This can be done on the car without any risk of changing any "settings"?

[@blue4u2008]

How does the earlier type come off ,its the one with the plastic middle not metal nut ?

[@maikhanecke7807]

Hello, is behind little piston a Spring? How long is the Spring?

[@uglsas]

Hello, do you repair/upgrade VW PD units?

[@mda420]

Hi can yo tell how to set the valve for the low loads that is right above the boost control valve?

[@valentinaperez7590]

Buen video...... Una pregunta el banco bosch que tienes es un eps 815

[@MAN-pl8cu]

Entonces girando el tornillo en sentido horario le das más paso de gasoil, o menos

[@matrixx991]

Hi dieselmeken, I have a problem because the little pin that adjust fuelling is stuck in my pump. How to make it moving?

[@thomasbreher9393]

Okay thank you found The spare parts. Fixed it yesterday, but it doesn't work. I have now no power ant the Peugeot driving now only 80. kmh. Bevor I repair it vmax110 kmh. I adjust the screw, so as it was before. There comes no smoke by the exhaust.

[@Lucas-wd3qs]

Hi, testbench Lucas DPC?

[@Naturkind-Daniel]

Hello, How do I get the pump head off? I have removed the screws on the side, but I can't pull it out. I have to change the seal. Thanks already

[@viking1ur]

Tusen takk - etter lang tid søken på nett for å finne ut korleis eg skal reparere dette har eg endelig fått hjelp. Neste blir å trimme min OM 314 slik at min lastebil LP608 klarer å følge trafikken + litt ekstra - kanskje du kan gi meg råd?

[@thomasbreher9393]

Hello, can you give me the spare part Number of the Membran?

[@viking1ur]

@@thomasbreher9393 Try this link sir. It is membrane for Mas 100: injectionpumps.co.uk/product/lucas-delphi-dpc-fuel-injection-pump-diaphragm/

[@DELEREUSD]

how to you make a vacum govend diesel pump roll coal?

[@aronalisson4975]

Tjena! jag har en caddy 1.9 Sd som jag vill ställa på. Jag tror att det är lucas pump. vet du vilken skruv de kan va? ä ju el Styrt tyvärr. funderar på evry mod men har ej lyckats få till dä :(

[@dieselmeken]

allen key is to be 2,5mm not 3 as I say in the video

[@kennethgrindberg5521]

dieselmeken Hei. Har du tilfeldigvis delenr på membran..? Mas100. 516695khf..?

[@Waltari71]

Partnumber for that part?

[@FFROID]

Hello, I want to replace the diaphram from my Peugeot J5 2.5 Turbo Diesel, because it is leaking. In Belgium we can not find a new diapram. So my question is, is it possible if in Sweden it it still available to send one to me in Belgium? Greetings Frank

[@RT-ng2sf]

Hello Frankie, You can find here , injectionpumps.co.uk/product/lucas-delphi-dpc-lda-boost-control-diaphragm-and-piston-kit-early-type/

[@jansalmi7869]

Jag får fasen inte den tät... Köpt nytt allt men läcker diesel

[@snailoneac9305]

Hello. I Have the same problem in my Peugeot J5 2.5TD. Please, can you sendme the information or the parth numer of this membrtan swap? Thankyou for your help and for this video. Carlos Doblado. From Spain.

[@mohamedammari7326]

Thanksgiving

[@izaiasgalvaogama7922]

Citroën 😐pensa em uma bomba chata

[@samodelkintv6942]

Give me number new kit