Direct To Film/ Sublimation Hack on WOOD!!! Will it work??????

[@caroljandreau7748]

Instead of the heat gun you can turn your heat press up to 385 degrees turn it upside down and put you sublimated paper on top of the heating platform for about 60 seconds just watch how quickly it cures your print to a rubber texture always make sure the powder is completely heated till your picture is dark then remove from heatEnjoy

[@onpointaccents]

Yep, I usually do the heat press. See previous videos I just wanted to try out my heat gun Thanks for watching

[@yanxacreations]

Hi it works. I used my clamshell though for 15sec..so perhaps not enough pressure on it, not sure. I do have a video on dtf sub on wood

[@onpointaccents]

Nice!

[@Kelli_D.]

I think the areas where the ink didn't come off, are where the powder wasn't fully melted. I'm having that issue with cotton fabric, and don't put your finger on the image before or after the powder is applied. It'll become part of your design. Learned this a few minutes ago when I accidentally touched my image to pick it up to shake the powder off it became a "clear" spot. but when I pressed it was there and wasn't part of the original image.

[@onpointaccents]

Yes never touch it it will really smear. Mine works great on shirts and stuff and certain types of wood

[@malmo54]

What about print on unequal surfaces? Have you tried?

[@onpointaccents]

No, only shirts and bags. This was my first time trying wood and it was just for fun.