Discovery 2 WHEEL BEARING swap! - Step by step how to video

[@CaponeIII]

Very clear, both verbally and visually. Thanks for the helpful video. I'll be doing both sides this week with more confidence.

[@Td5Adventures]

Thanks for watching and good luck!👌🏼

[@SurvivalRussia]

I know this is an older upload, but I appreciate it a lot. This will come in handy changing hubs on my Range Rover. thank you for your time buddy!

[@Td5Adventures]

Thank you! Good luck, the P38 and D2 share the hubs so it should be a very similar job😊

[@DanielHeini]

Great video and very well explained! You make me more and more keen to buy one of the Disco 2's I made a testdrive in the last weeks :-D And a compliment to the cameraman sometimes a little trouble with the autofocus but the closeup filming was excellent so you could see everything what is important for this job. Regards, Daniel

[@Td5Adventures]

Thank you!!! Yeah I was really happy my girlfriend could film the first half, so much better than with a tripod in the second half... Oh nice, you will find one soon😎

[@MrMaxEf]

You don't have to undo caliper from carrier. You may just undo carrier with caliper together. Did last week)

[@Td5Adventures]

Ah, clever!!

[@johnwannable]

Great video, thanks! About to tackle this along with ball joints as I didn't pass inspection here in the U.S. Need to buy a 32mm impact socket and a torque wrench that goes to 500!

[@Td5Adventures]

Oh god luck! There are hardware stores here in Sweden where you can rent certain tools, maybe you can rent a wrench or just calculate the length of your bar and your weight to get a torque spec😉

[@andrewfryer7488]

Great video shame mine fell apart on removal leaving the 4 bolt carrier seized to hub lol

[@Ja518]

Very good video. Thank you

[@bobbyyy776]

Great video 👍

[@Td5Adventures]

Thank you!!

[@joekrakowiak9487]

Can you use a wheel hub for a Discovery 2 on a P38?

[@Td5Adventures]

Yes, from what I know the hubs are interchangeable!

[@jerryallen34]

Great how to. Thank you

[@Td5Adventures]

Thank you for watching!

[@sal1520]

What brand bearing hubs you got mate

[@APromProm]

Thnx, Great video! I hope you didn’t forget to secure the 32mm locknut ;)

[@Td5Adventures]

Thanks!! No, it's fine, I have secured it 😊👌🏻

[@MrMaxEf]

I've got 36mm nut! Got to buy head

[@fraggle23]

You don't need to take the abs sensor off, just leave it alone, especially as the new hubs all have them attached

[@fraggle23]

But good vid generally

[@fraggle23]

And any time you change a hub you should take the opportunity to change the axle seal

[@Td5Adventures]

Sorry for my slow reply... Yeah I should have bought an axle seal! The abs sensor does not need to come off, you're right. But in this case only the sensor was bad.

[@andywood492]

How do I replace the wheel bearing if I don't want to replace the hub?

[@Td5Adventures]

You can't! It's a single unit all together.

[@samuelbhagothiparsad3882]

Its a wheel bearing hub. You did not replace the wheel bearing. You replaced the complete wheelbearing hub assembly. I say this cos I was told my wheel bearings were shot. walked into autozone, they ordered and sold me 4xwheelbearings and only found after stripping that I needed the complete hub assembly.

[@Td5Adventures]

The only way to replace the wheel bearing on these is to replace the whole hub. Your hub doesn't go bad, the bearing inside it does.

[@christophrosa1651]

Super Themks.