DIY 6" FUME and SMOKE Extraction for Your Laser Engraver

[@MadeitTuhMidnight]

I’m looking to add a filter on the exterior. Because, welp, this particular exhaust duct only smells of skunk. Though I do have a large enough area with our yards, I’d like to filter some of that. Ideally, it would go underground.

[@workbenchz]

Nice job with the vent. Yes a 6" hole saw is dangerous, if it snags and kicks the drill could break your wrist (happened to a friend). If your drill accepts a side handle that can help keep it under control.

[@sethcraftworkshop]

Those large hole saws are very dangerous for sure! This drill was not very powerful and would stop if something snagged.

[@jllaine]

That's a Huge Laser.

[@sethcraftworkshop]

It is a big one. I have some big plans for it too.