Dual action air atomizer cast iron melting burner Clog free operation

Рет қаралды 8,313

Күн бұрын

Clog free operation is important as waste oil can be difficult to work with .
Please copy and paste links as youtube dings my channel for causing you
to leave .
Check out my store front www.ebay.com/s...
Check out my web site www.nobox7.com/
Check out my store front www.amazon.com...
Support this channel on Patreon www.patreon.co...
Email me optimizedprsllc@gmail.com
Call me if your interested in this product or have a design to commission 001-217-710-9653
This video contains paid links that receive a commission from if a sale is made

Пікірлер: 23

@NOBOX7 7 ай бұрын

Sorry about the sound , it was not this bad in editing

@kalleklp7291 7 ай бұрын

I'm not pre-heating the fuel either, for all the reasons you mentioned. What I made is three slopes with a 1/2" pipe on top of my burner to get the air preheated a little more. On mine, I have installed a blower at the back which is essentially the same principle as your leaf blower (leftover blower from an old forge), and a line for compressed air. For aluminum melting, I can cope with the blower when I melt copper or bronze I use additional compressed air.

@Concreteblockmachineug 7 ай бұрын

That's a nice blue flame..

@josemanon6295 7 ай бұрын

Becoming my favourite channel 🔥🔥🔥 Even good lens magics at 8:52 🌈

@ARandomTroll 7 ай бұрын

I approve of the can over the square burner. definitely helps with efficiency, Tough I doubt the air tube preheat on the baby godzilla is needed in this case. It might help burn dirty oil but that's mainly a problem during warmup where it won't do much anyways. For startup, you could try starting it on propane and then switching to oil once it's hot. This thing could also make for an interesting test bed. the section between burner and blower is just asking for a heat exchanger or nichrome coil. For testong you could literally just put a second burner on the heat exchanger.

@independentliberty9628 7 ай бұрын

Man if you keep it up one of these days youre going to have to be building burners out of tungsten. Lol. Love seening you push the limits.

@jmikronis7376 6 ай бұрын

You are edging closer and closer to the conditions of what AgentJZ has shown for the stages required for commercial jet engines.

@mopclabs 7 ай бұрын

Sweet

@milesrost6674 7 ай бұрын

Wow, cheers

@5002strokeforever 7 ай бұрын

I do successfully pre heat my oil, but I use heated coolant to do it. I also had issues with the boiling oil causing voids, solved this by having a positive displacement pump, little valve that maintains backpressure as close to the nozzle as possible, and a tiny nozzle orfice. Unfortunately all that isnt really feasible on smaller, more portable setups such as yours.