Was the overhung impeller already balanced or taken into consideration?
@ontarioelectricmotorman73092 жыл бұрын
For this case, we balanced the impeller first because it was too much out of balance. We made a new shaft for the impeller balancing, after that we put the impeller on the rotor and balance again. In most of the cases, you can balance them together.
@twintwo14292 жыл бұрын
@@ontarioelectricmotorman7309 good practices. In our shop, we found that up to 20% of new impellers are not balanced to G-1 SPECS. same for various other attachments also. We had a customer complain of excessive vibration in a hazelton pump we rebuilt, less impeller. They installed a worn impeller with improper gap at wear ring. Go figure!!!.
@ontarioelectricmotorman73092 жыл бұрын
@@twintwo1429 yes, we would need the impeller, pulley or coupling sent in with the motor, unless it is a small unit.
@twintwo14292 жыл бұрын
@@ontarioelectricmotorman7309 👍
@alexandergarcia3812 жыл бұрын
Saludos, como saber a cuantas RPM debo ajustar la realizacion de las diferentes pruebas en funcion del rotor, existe algo de guia? De antemano gracias.
@ontarioelectricmotorman73092 жыл бұрын
Por lo general, la máquina equilibradora recomienda la velocidad de equilibrado al menos 1/3 de la velocidad de funcionamiento. Por ejemplo, la velocidad nominal del motor es de 3600 rpm, elegiría 1200 rpm para la velocidad de equilibrio. Sin embargo, cuanto mayor sea la velocidad que elija, mejor, pero no menor que 1/3.