Dyno tuning a 9 second BMW G82 M4 in ONE DAY! Over 700HP!

Couple weeks ago we sent out my buddy Miguel's ECU to Femto for the unlock. We got it back in 8 days and on day 10, we dynotuned it. Check out the video to see what power she put down and how it ran on the street to back it up! If anyone is interested in the same service, reach out to me in the comments or DM me on Insta. Let me know what you think. Would appreciate a like, comment, sub, share. Thanks for watching!
Mods: MAD Catless DP + Valvetronic Catback Exhaust
Shop: Maximum PSI/Bimmer Clinic
Tuner: Pureboost/MHD Tuning
Follow @phillybimmerclub @g80_soom @g82m4_comp_nj on IG for more content.
For all parts/discounts: linktr.ee/g80_soom

[@TheCarKrazeOfficial]

New m3/4 is such a beast

[@phillybimmerclub2902]

Def is!

[@birch4209]

Beast mode

[@phillybimmerclub2902]

🤝🏾💪🏾

[@WhatsyourForte]

good data

[@phillybimmerclub2902]

🤘🏾🤘🏾

[@Jquick5156]

So knowing what you know to this point. If you were going to pick up a new car. Would you go rwd or x drive? I think these will be monsters but the small drive shafts up front is a questionable weak point.

[@calimade8136]

Might wanna dial the torque to stay under 600 to save that motor.

[@phillybimmerclub2902]

I’ve been running 700tq on mine for past 8 months with 100s of runs. Stock rods can handle up to around 740

[@calimade8136]

@@phillybimmerclub2902 that's good to know, I heard 650 was the limit and to stay around 600 for no issues.

[@jockolacko8181]

@@phillybimmerclub2902 wasn’t it the transmission that had an issue with that? You have a manual i think the A8s don’t like over 650

[@mikepollard57]

How's it bro I have a question about the clutch and flywheel change I recently did

[@phillybimmerclub2902]

What’s the question?

[@mikepollard57]

@@phillybimmerclub2902 did u have any problems with the rev matching working other than that the upgrade was unbelievable the difference the lighter flywheel made

[@phillybimmerclub2902]

@@mikepollard57 No the rev matching works just like stock for me. I had an issue with 1st gear engagement after installing but I replaced the clutch slave cylinder and that fixed the issue.

[@mikepollard57]

@@phillybimmerclub2902 I didn't notice before but does the rev matching only work in certain modes?

[@phillybimmerclub2902]

@@mikepollard57 Rev matching works in all mods. Just gotta make sure it’s turned on in your setup and M1/M2 modes

[@S58AJ]

My car is next please!!!

[@phillybimmerclub2902]

Gotchu brotha!

[@Bxwing-cp2cm]

Should def get a diff lockdown kit and poly trans mounts.