Early Model Dyna Chain Conversion

[@justinelliott1550]

You said it wasn’t a how to… but this was one of the best on KZbin lol. Nice video

[@jeffboyardee777]

Thanks man! There’s a few parts I left out, like removing the starter from the inner primary. But it’s essentially everything there is to a chain swap.

[@avo_fg2]

Great video to follow along to, I can now do the same to my bike!

[@koonsickgreen6272]

great vid! No alignment issues at all?

[@unknown.5982]

I lost my bolts for that lock plate on the sprocket do you know what those are called?

[@B4TheFlood]

So did jam a half inch bar in the sprocket for chain slack? If so that’s a good idea

[@jakespeed9419]

What year?

[@jakespeed9419]

What was the offset??

[@nightmaremike1092]

Did you have to cut the chain?

[@moosemancummins4654]

Has this allowed you to fit a wider tyre on ?

[@jeffboyardee777]

@@moosemancummins4654 I didn’t add a wider tire, but you can. Just need to be careful not to go too wide to prevent the chain from rubbing the sidewall of the tire.

[@moosemancummins4654]

@@jeffboyardee777 yeah how much more room between the standard 130 tire and chain is there now ? Think max you could do with belt was 140. Bicycle tire !!

[@harleysguitars7850]

What year dyna? Is the main shaft nut that you used the high torque gun for reverse thread so righty loosey?

[@jeffboyardee777]

It’s a 2001. Yes reverse thread

[@harleysguitars7850]

@@jeffboyardee777 what about the 2 and 1/4 tranny sprocket nut? Tx.

[@lorenzosanchez7356]

When you put the wrench in between the sprocket and the chain and then Tightened it, was that a quick way to measure chain tightness or making sure doesn’t move?

[@jeffboyardee777]

It's a trick to put enough tension on the chain to make sure the axle is seated against the tension adjusters nicely before you tighten it down@@lorenzosanchez7356

[@izgal863]

How’s the left passenger peg? Did you have retrofit it with the chain conversion