How to connect your Centurion D5 Smart gate motor to your alarm system as a zone for tamper.

[@jbudd78]

Just add a 15w siren as per the first part of the clip and save the complicated alarm integration. I did that, and it works perfectly. Always armed, and you can set the sensitivity on the app. The alarm siren cable is in steel conduit to prevent thieves cutting the siren cable. Nice video. Wel done for figuring out the alarm integration!

[@theonlydavide]

Thank you for this video, very informative. Will it be possible to connect to the I/O but with an external 12v power supply, or should I say without using the 12v from the Gate controller? Thanks again, really enjoy your videos.

[@ashrafkarjiker6888]

Can you demonstrate how to wire camera intercom to open the gate

[@brendanmcn4505]

Thanks for the video. Is it possible to connect to an alarm wirelessly?

[@ecologicaltime]

yes it can be done, you can get a universal wireless connector or use a remote that is hard wired and its receiver is then installed on the alarm side. I may do a video on this in the next few weeks.

[@allenbubb6800]

Good day. I need some help. I have a xwave Reciever and 2 xwave pir. But it does not seem to be able to get them to work?

[@pmbpawnstars7200]

Thanks for the vid!, possible to connect a 220v pillar light wiring set up....d5 evo was easy, but not on the one.

[@amitshiba26]

Wow thank you!

[@derekvandermerwe9039]

The later model D5 Smart has a 24v output thus need a 24v Relay.

[@نِبّضًعَآفُےهِ]

Peace be upon you how are you Can I help you project about smart gate for waist university

[@amitshiba26]

Thank you for making the installation so simple , just a quick question for the alarm siren feature must you have ana external siren or would the unit have a built in one?

[@ecologicaltime]

thanks, you need your own siren

[@amitshiba26]

@@ecologicaltime thanks for the response much appreciated

[@danierossouw5404]

Hi. I have two Centurion D5 Smart Motor and I connected both of them on my alarm for a tamper alarm. I also have two relays for the automation. If i bump the gate for an alarm my other gate triggers. What can be the cause? The gates is Zone 8 & 9 and the trigger is on PGM 1 & 2 each having its own relays?

[@danierossouw5404]

If you have a solution for this please let me know. 083 230 1194

[@larrygael7892]

Very happy 😍💋 💝💖♥️❤️

[@De_ebumars]

Can we talk I need your assistance

[@MrMochini]

I am doing mine currently, I will however define the zone as panic zone because I want the motor to report tampers 24/7. Informative video otherwise