ECU Tune Install - Speed Triple Mods & Maintenance 4

[@kenwolfe5697]

I just recently did this to my 09. I’m running the same map with a high mount GPR Exhaust. I noticed a little bump in power but also it really smoothed out the throttle on corner entry after hard braking. Makes the bike even easier to ride fast. I also just bought Speed Triple R PVM wheels to retro fit to my bike. REALLY excited about that.

[@nightninja8128]

Bro, the Triumph sounds epic! Also, Driving 4 Answers has an excellent video on VE tables that I personally found helping/insightful.

[@pablononpicasso1977]

Love the growl and mild pop from that triple. Much smoother after the ECU Tune. I might try that on my Aprilia.

[@se11459]

Fantastic job all the way round on this video. Information was on point, great pacing, video editing, voice over, all of it! Much appreciated.

[@cullenmichael34]

Awesome stuff. Love the content. I will admit, when I last used TuneECU for my aprilia, I didn't dive in as deep as you did. While the triumph guys are huge into this program, it's big with the older rotax Aprilia guys too. There's a fella who goes by Catfish who has made legendary tunes for the Caponord and Futura. They came rev limited by the factory to a lower spec than its RSV cousin. Simple flash and you get better mpg than stock and more horsepower

[@MyRandomLife247]

Sounds mint! However, in regards to your comment on getting a steering damper. I see a lot of guys do this, you're better off spending your money getting your suspension setup for your weight as well as the tyre pressures. I had a 2021 MT09SP that used to tankslap like mad on full throttle. Literally all I did was add in a couple of turns of preload into the rear shock to add more weight on the front and the tankslap went away. No damper needed.

[@Theillestrator1050]

Suspension is something I always had bad experience with in the past so I do in fact usually skip messing with it. I got a bad leak on the left fork so I should kill two birds and look into getting it set up along with the seal change.

[@goldie6579]

You’re riding around my old neighborhood. Haven’t been on the “Interboro” in ages. Bike sounds amazing

[@CNDUK-q8r]

Love your Speed Triple - awesome looking and performing bike. ♥

[@upsidedowndog1256]

Sounds real good! I don't like when my headlight is louder than my exhaust so I installed a Delkevic exhaust on my rebuilt from a total 2012 VStrom 650. It got an LED headlight once all of the fairings were removed.

[@Theillestrator1050]

Lol. How is the delkevic

[@upsidedowndog1256]

@@Theillestrator1050 A little quiet but very well made and affordable. My other bikes are all obnoxiously loud so I guess one quieter one doesn't hurt. Much lighter than stock.

[@mattus1gig]

A nice quiet little test run 😁

[@Theillestrator1050]

Quiet 😂

[@stratokast4730]

Yooo he's back

[@johan5512]

Cool man, Great video. I wish in knew the ECU stuff with an android when i had my speed triple. But great to know for my next speed triple. Gosh its a good bike, and that engine is so powerful in all ranges.

[@Jupitersonlyson]

Wow the sound!!!! Like a savage!!!!

[@markopolo945]

👍😎👍 Great Post! Thanks for educating me. Man, this bike sounds so good!

[@Theillestrator1050]

Thanks for checking it out!

[@markopolo945]

@@Theillestrator1050 🤜⚡🤛

[@whatsgoingon27]

The rev limiter sounds godly now 8:28

[@earlroberts2069]

Got to love the Jackie!

[@Theillestrator1050]

Seriously. The best road around here.

[@earlroberts2069]

@Theillestrator1050 Canarsie to LaGuardia airport every day that was my route on my MT09. PS- I met you years ago on Flatlands (Southshore High School) when you rode the Fz01.

[@kanadezosGT]

Damn boiiii!!! That a hooligan machine right there.

[@hellbilly6532]

The bike sounds awesome

[@FunWithAJ]

The good old VAG port.

[@Theillestrator1050]

Tried and true 😂

[@siphongubane7095]

Sounds magnificent ❤

[@lexus996]

A little tune makes all the difference. 🙂

[@MrEye4get]

Can ECU Tune adapt for changing sprocket sizes? On newer Triumph EURO 5 models changes will display "Code P0915 - gear shift circuit range/performance". Additional information indicates "vehicle speed doesn't match gear." This is due to gear position, rpm and wheel speed being constantly monitored by the ECU. It seems the new Euro 5 ECU maps engine RPM against road speed for a given gear.

[@adeyinkaadeoye9343]

Thanks for posting this.

[@CedricParker]

whats good, I haven't seen anything new in a minute

[@marbonbella693]

I have a 2012 with the dnk flash. Have you been able to find a steering damper and if so who makes it? I came across 1 that may work but im not spending $550 for the ohlins and no bracket.

[@cordanez]

How's the beam pattern with those LED bulbs? No hotspots or incoming drivers flashing their high beams at you? Hopefully they're at least better than the stock halogen bulbs, which have a horribly scattered pattern on my '06. Also, were these a straight drop-in installation? I had to return a set of Auxito led bulbs that Amazon said would fit my bike. I would have needed to enlarge the hole in the reflector housing to install them and I wasn't about to do that. Lastly, I've never understood what those tiny bulbs at the bottom of the headlight buckets are supposed to do.

[@razor1uk610]

@cordanez ..sorry to ask/say, *Why would you trust Amazon to know anything about motorcycles.....??* (sorry it's hard to not sound/read-as incredulously vexed at your assumption) It is likely those bulbs were for a car, as most bikes of the last 10 years all use the same reflector aperture diameter size, unless they're PRC Chinese made tofu-dreg machines.

[@cordanez]

@@razor1uk610 I was curious.

[@Theillestrator1050]

They're pretty good. I installed them at the beginning of the year, they're still running good. They aim low like they should. And yes they dropped in. I think the little bulbs are "marker lights"? I've had a few bikes with them featured. Like my sv1000 had the mini bulbs at the outer corners.

[@BikerBenny]

Thinking of biying a 2007 speed triple near me. Says no signal from one of thr injector. Wonder if this software would help me figure ot out

[@gersonmoreno5791]

I need that ECU tune in my is a 2005 , im in Brooklyn

[@1LifeTheory]

I need to do this on my 1050. I feel like it bogs at certain spots in the RPM band. Did you notice that at all?

[@dieselmonster]

How is your flying brick?

[@Theillestrator1050]

Flying brick is still kicking. I barely use it though if I'm honest lol. I should def make some content with it.

[@adeyinkaadeoye9343]

@@Theillestrator1050 Please do!!

[@Amarusan298]

bro I love those gloves! what brand are they?

[@Theillestrator1050]

These are street and steel Oakland gloves. I'll warn you though, they're not that durable.

[@H3K7iC]

Does this mod work on a 02 Speed Four?? TT600 pretty much

[@aaronm402]

Hi what pipes have you on your speed ...very tasty...

[@freemenofengland2880]

Isn't the ECU on the 1050 Japanese? Built by Keihin?

[@FlyXenonRC]

My 05 is keihin

[@OCCUPIEDNATION]

You should be pretty safe with a 9,700 rev-limiter - even some of the older Gen One Triumphs could manage that.

[@ANSWERTHECALLOFJESUSCHRIST]

Dude, WE MISS YOU!!! Please report! 😢

[@DankoStojanovic]

8:32 Mexico looked cold that day

[@Theillestrator1050]

México is a diverse experience 😂