Electrochemical Machining (ECM)

[@drjarikrishnan7480]

Good evening sir, your video is very nice. But very little correction Fe2+ ferrous.(Fe3+. Ferric). ( FeCl3. Ferric chloride) Fe(OH)3. - Ferric hydroxide. Time:16.45 minutes Dr J. Arikrishnan.

[@rock3tcatU233]

Great lecture, a lot of valuable information was given here.

[@sagarsaini5598]

mass flow rate? volume flow rate? concept of overvoltage? These should also be included in this video.

[@philbertmuhayimana8290]

Thank you so much professor . I would like to embark my research in this machining process. considering a hybrid wire EDM, combined with ECM. I would like to know the choice of electrolyte . Because i want to change the Dielectric of Wire EDM to an electrolyte.

[@mohitmittal4188]

That such kind of professor Same to iit roorkee

[@ermiramehmeti6526]

Is there any video about any process?

[@haftuhiluf1266]

thanks prof.

[@sumansaha955]

IIT KGP videos are more helpful than this.

[@Ihavetoreturnsomevideotapes]

u KGP gay

[@kumar08ARO59]

Thanks, professor .