EMCO Maximat V10-P-Refurb.

[@angelramos-2005]

Good work,Cliff.The cross slide and tool post look good to me.Thank you.

[@retromechanicalengineer]

Nice one Cliff. My V10P had some maintenance last week. Cross slide and saddle off for a thorough clean, new cross slide lead screw bearings and oil changes in both gearboxes. Yours is looking spanky. Best wishes, Dean.

[@philhermetic]

Good stuff Cliff, its looking realy good! Watch the adjustment on the rack as that will put pressure on the repaired lug! Phil

[@624Dudley]

Looks a lot like a lathe! 👍

[@tropifiori]

My carriage feels like there are tons of chips stuck in it somewhere, but I cant sort out why it feels that way. will take it to bits and start over.

[@anfieldroadlayoutintheloft5204]

great vid on channel keep up the cool vid you do thanks lee

[@77miketodd]

She’ll soon be up and running 👍

[@shaun30-3-mg9zs]

It's looking good Cliff, great video

[@grahameblankley3813]

Enjoying watching the build, but you did a double take on fitting the cross slide, did you know?

[@router5840]

A good trick for slotting Cliff is put two blades in the saw.

[@CliffsShed]

I'll remember that, thanks, better than the way I've been doing it, always ends up tapered til" I needle file it!! ATB, Cliff

[@brianclark2370]

Hi cliff. The black Cover is ment to move with the crosslide. From Brian west germany p.s cliff down load the use Manuel it will help you keep going looking good😊😊😊

[@65cj55]

I don't think so, if it moves it will allow chips into the cross slide screw.

[@retromechanicalengineer]

Mine slides with the cross slide. There is a stop at the rear to prevent it going too far. As it slides, it prevents chips getting onto the cross slide lead screw.

[@65cj55]

@@retromechanicalengineer Mine doesn't, it's there to cover the screw in full.

[@retromechanicalengineer]

@@65cj55 it must. Otherwise the top slide wouldn't move. It doesn't go far, as there is a rectangular window let into it that the lead screw nut fits into. The cover sits in grooves let into the saddle, which allows it to articulate.

[@65cj55]

@@retromechanicalengineer No mine just has a slot for the nut, even at full extension the srew is never exposed.

[@cporter1775]

I had a similar machine cast piece break years ago and preheated,DC stick welded and peened, post heated while hammered peening with success.

[@CliffsShed]

I'm just hoping my bodge doesn't come back to bite me, ATB, Cliff

[@albertfuller8624]

Soon be making chips