Enya 09 Mk IV a Look Inside

[@OlliKarhun]

Hi, Did you get the 10 size 2 stroke engine comparison done? I have not found it

[@dmrcflyr2]

kzbin.info/www/bejne/maa3dqeejNSUitU

[@spektrum33]

I have one ,and it’s a sweet little engine for its size

[@061811]

how did you take it apart? what temp and for how long? I tried but the shaft wont come off thx

[@charlesbovalis6591]

Hey David, I could not see / hear the product name ( tube ) you are using to create gasket .. Do you mind telling me the name again ? Thank you.

[@dmrcflyr2]

www.permatex.com/products/gasketing/gasket-makers/permatex-motoseal-1-ultimate-gasket-maker-grey/

[@charlesbovalis6591]

@@dmrcflyr2 Thank you !!!!!

[@keithrx3c]

Are these the engines that people used in the Kyosho Advance/Assault buggies?

[@TMCarter1]

I just picked one up on ebay after watching this the other day The muffler is on the other side though and has what I think is a priming access gate

[@TMCarter1]

I could not get my 09 mkIII to run today, two hours and I gave up After complete clean and rebuild it just won't run 😔 Glow is good compression too My one has a threaded rod that holds the needle and I fear I haven't returned it to its correct position in the venturi Also made sure the larger side of piston baffle is at exhaust side I'm stumped

[@jamesbonde4470]

Use WD40 and heat.