EP.5 | Building A KA24DE Head

[@dantimmerman6693]

On your next build you can use some VQ35 lifter buckets. They're a one piece unit with no shims. As long as you order the right buckets for your valve lash specs she'll be running strong. You'll gain some RPM because they're much lighter.

[@thomassmith6969]

I noticed you didn’t switch out your stock valves for upgrades like stainless steel valves or use titanium retainer locks, ( collets). You might experience valve stem sheer if you plan on high RPM. It’s always a good idea to replace all valve train components with upgrades and not just some of them. You may end up with an expensive mess.

[@MemelordJord]

thomas smith yeah over the winter I actually did get tomei oversized valves for it and the head has been at the machine shop since February and i have a bunch of extra caps so i can get the lash set probably

[@thomassmith6969]

Make sure you check cam to valve bucket gap. I’m sure you spent a good sum of money on your cams I would hate to see those lobes rounded off.

[@Dylanschillin]

Tomei makes some of the most affordable camshafts on the market

[@802Garage]

Nice work. Buying a lot of good parts! Good luck from one small car channel to another. You might look into powder coating at home. I just released one video on it and my next should be out today. :)

[@KSA-vh6tv]

Great job. 👍🌹

[@maddida]

How much power did this thing make

[@ghostofthedeep]

One critique I would like to make is the OBX pulleys or any similar pulleys are extremely bad for engine harmonics you want something like an ATI or any other purpose built fluid dampener that's meant to absorb vibration those pulleys are not meant to absorb vibration there meant to look pretty

[@fabiolasolis1659]

Thanyou men wood woork all ways from mexico city👍

[@jacobgross4519]

Was your rear cam journal on the intake cam undersized by about a mm? Did the cam cap "float" on the cam?

[@MemelordJord]

If you have aftermarket cams they’re supposed to be like that and apparently you aren’t supposed to plug the oil hole either

[@jacobgross4519]

Thats what i keep hearing but how does it retain oil pressure then?

[@Dat_S14]

Where do u get those pulleys ?

[@MemelordJord]

Ebay but i don’t think they make them anymore

[@hdhellion4128]

I'd watch a real time build. (Not time lapsed)

[@adrianheredia_ac1842]

So uhhh, who screamed? (4:51 - 4:58)

[@TheLastSoundNinja]

Ghost

[@Dragonfabb]

magnet, socket, hammer to remove! makes it toooooooooooooo easy

[@danielbello6789]

Good woork 🤔

[@WraithDeath]

“How to build a KA24”-You get rid of it