EP3 Catch can fitting - installation.

[@TheWarewolf79]

Hi, since it's been a while now since your install, how are you liking your catch can as I am thinking of getting one for my supercharged car? Thank you.

[@westestmodified8645]

It's not bad. Only a very basic setup but it does the job. Some people are using breather filters and some are using AN fittings from the rocker cover into much more expensive catch cans, but I wanted to try this setup first to see how well it works and in all honesty it was a way of controlling any oil mist from being pumped into the bay as the cans baffled and also to see what exactly is being vented. Thanks for watching and I hope this helps you in any set-up you're thinking of using.

[@TheWarewolf79]

@@westestmodified8645 Thank you for your swift positive response...this catch can seems to be very popular and of good build quality...best thing about it is that it's fully sealed and has a proper inlet/outlet fitting size of 19mm (3/4 inch) just like factory size which helps vent/breathe better...So did you run the outlet from catch can back into intake later on, or you're still running this setup the way you initially ran it? If so, did you notice oil vapor/mist coming out of CC outlet splattering the engine? How's the smell inside cabin? Finally, did you notice any issue running it vented rather than sealed? Like vacuum change/high idle and was there any effect on power? Cheers buddy.