Epic 6-Hour CNC Electronics Retrofit Crushed into 14 Mins: The Ultimate DIY Overhaul!

I show a typical CNC electronics retrofit.
Official Link:
buildyourcnc.com/
If you need help with your CNC electronics, get in touch with us at Buildyourcnc.com
Wire Stripper I mentioned in the Video (Hard to Find):
amzn.to/3OiAncF
Check out some other tools and equipment I recommend:
www.amazon.com...
I may receive a small commission from the Amazon links.

[@PatrickHoodDaniel]

Thanks for watching. Let me know what you think.

[@soniclab-cnc]

LOL. that giant linear power supply. Big ol toroidal transformer. There are two schools of thought on the linear vs switch mode power supplies... I won't start a spitting match over it. And yes I always use wire ferrules. You just have to take the time and make sure they are fastened down well. I have had issues with bare wire connections and very few when using wire ferrules. For low voltage stuff they are fine.

[@PatrickHoodDaniel]

God, the toroidal transformer is HEAVY!! I would use switch mode just for that. By the way, I don't mind the discussion on the supplies as it helps the algorithm. Thanks for the input on the ferrules. Let's keep that discussion going too. Haha.

[@joecnc3341]

Tremendous cost and space reduction with modern components! Each one o those gecko drivers were $200-$250 "Back in the day"

[@PatrickHoodDaniel]

I know! They are great drivers.

[@jonathanjoffe751]

Oh ha this is mine. Got like 2/3 through the video before I realized.

[@PatrickHoodDaniel]

It's actually not. The components are very similar. You'll see that I say that the customer did not provide the motors, but you did.

[@PatrickHoodDaniel]

Your cabinet will be much nicer too because it will be brand new. The cabinet that I'm showing in the video is the customer's cabinet

[@jonathanjoffe751]

Oh derp also I didn’t send you an Ethernet smoovestepper. I’ll get you the machine dimensions this weekend.

[@jonathanjoffe751]

Oh derp also I didn’t send you an Ethernet smoovestepper. I’ll get you the machine dimensions this weekend.

[@jonathanjoffe751]

Oh derp also I didn’t send you an Ethernet smoovestepper. I’ll get you the machine dimensions this weekend.

[@dineshm4582]

Where can I buy this

[@PatrickHoodDaniel]

Buildyourcnc.com