etrailer Stabilizer Jack Review

[@tedbaxter5234]

Don’t forget to retract them before you take off! Thank you for the video!

[@etrailer]

You're very welcome. We're glad you found the video helpful! That is really good advice. We sell tons of these jacks because people forget to do this... www.etrailer.com/Camper-Jacks/etrailer/TJ01RT-HD.html

[@cesarpalmos8235]

A cool side benefit is you can lower your rear stabilizers, then raise your tongue jack slightly to prevent your tires from getting flat spots during long periods of storage.

[@etrailer]

You should be okay as long as the loaded trailer weight doesn't exceed the capacity of the stabilizer jacks and the jack on your trailer tongue, however the stabilizer jacks aren't really meant to do that. www.etrailer.com/Camper-Jacks/etrailer/TJ01RT-HD.html

[@LoveItDirtyOffroad]

Seems like they would control the load better if turned 90 degrees since the "rocking" happens front to back when loading and not so much side to side.

[@charlesstevenson5141]

Looks good for smaller trailers. Especially for tear drops and camp kitchen builds. I would definitely go with a locknut and bolt setup with lock washers. I'm not a fan of self tappers, especially in places that would have that much movement.

[@etrailer]

You could definitely use bolts and nuts to secure these stabilizer jacks to a trailer. www.etrailer.com/Camper-Jacks/etrailer/TJ01RT-HD.html

[@nickrobinson9503]

Run a couple welds

[@cleopooch8640]

I know you burned yourself grabbing that tek screw after zipping it out lol

[@danhopkins2374]

You want the customer to have to jerry rig your product? With a problem you know it has? ?

[@Sluggo01]

These do not hold well…junk..they slip loose