EWRF TS5823 Transmitter connection and data sheet Explanation

This video explain the EWRF TS5823 Transmitter to FPV camera connection and detected by FPV monitor/receiver
Battery in the video is 2S LiPo 7.4V to 8.4V
EWRF TS5823 Data Sheet link:
www.google.com/url?sa=t&rct=j...
Purchase EWRF TS5823 + FPV Camera link:
www.lazada.com.my/products/ew...
If you like this video:
Please Like, comment and share this video with your friends.
Please don't forget to subscribe to my channel :)

[@PetrKvapil-nt6jw]

You are the best KZbinr

[@LYSStuff]

@@PetrKvapil-nt6jw thanks for your support

[@PetrKvapil-nt6jw]

Please support me also

[@gregariousgreg8413]

Thank you for helpful video.

[@LYSStuff]

My pleasure 🥂

[@MangoJim90]

Thank you a lot!!!! Good idea about heatsink! It is really hot, I was thinking about installing little fan, but it is difficult to find a sourse of power for it.... heatsink is great!! Forgot about it ... thanks a lot!!! :>

[@LYSStuff]

My pleasure 🥂😁

[@3dmodelinghamid238]

Thx very intersting

[@LYSStuff]

Welcome and thanks for your support

[@LsGamerOficial]

Boa amigo, voce pode me ajudar ? Qual bateria vc usa para fazer seu transmissor funcionar ?

[@LYSStuff]

Hi, This is the battery that i used 2S Cell 7.4V, 850 mAH, Brand "Shang Yi". You may refer to this video. kzbin.info/www/bejne/iJWQhpmjopqLiqs Hope It helps. :)

[@mohithcg12345]

Can I use a 3s lipo battery for powering the transmitter?

[@LYSStuff]

Hi, Yes. The DC power supply is 7 to 24V From EWRF TS5823 DATA SHEET www.aliexpress.com/i/1005005430416830.html Info about 2s vs 3s lipo battery for confirmation. www.google.com/amp/s/blog.ampow.com/2s-vs-3s-lipo-battery-comparison-between-the-two/ Hope it helps. :)

[@normalperson4925]

Hello sir, what battery product did you used for the TS5823?

[@LYSStuff]

Hi, This is the battery that i used 2S Cell 7.4V, 850 mAH, Brand "Shang Yi". You may refer to this video. kzbin.info/www/bejne/iJWQhpmjopqLiqs Hope It helps. :)

[@adamazri9562]

If i use 11.1v 3s or 22.2v 6s lipo the camera will work just fine ah? No boom boom one?

[@LYSStuff]

Hi, It wont boom, the transmitter support range is 7-24V. if the datasheet is correct...hahaha

[@PerchEagle]

Can I use other FPV VTX other than this one ? Because I want more flight range; like, +2km.

[@LYSStuff]

Yes, you can potentially use other FPV (First Person View) VTX (Video Transmitter) units to achieve a longer flight range for your drone. The FPV VTX is responsible for transmitting the live video feed from your drone's camera to your FPV goggles or monitor. Different VTX units have different specifications that can impact the range and quality of the video transmission.

[@PerchEagle]

@@LYSStuff OK, so the VTX you're using is a budget one right ? I hope you post other videos of using other VTX modules; like, rush tank or other VTX modules that are used in FPV builds.

[@LYSStuff]

@@PerchEagle yup, my one is budget one.

[@PetrKvapil-nt6jw]

What battery do you use for the transmitter?

[@LYSStuff]

Hi, I'm using 2S LiPo that 7.4V to 8.4V

[@MauM0505]

Any chance I can get the tyro99 OSD in this?

[@LYSStuff]

Hi, I'm not sure will the tyro99 app able to detect this transmitter FPV signal. But theoretically is yes if tyro99 able to scan the FPV at the 5.8GHz frequency range

[@MP-gi3fv]

Can i use it in the radiolink rc8x

[@LYSStuff]

Hi, this can't use it for radiolink rc8x.. Because the frequency channel is different. Radiolink rc8x is 2.4GHz. This is for 5.8GHz

[@PetrKvapil-nt6jw]

Can i use 6,6V 1000mAh 8C Lipo baterie

[@LYSStuff]

Cant, minimum power supply required is 7V, kzbin.info/www/bejne/e3PUp6ywn9qsr6csi=Wg-K4hEinbpaYKm0&t=263

[@eurobeatmachinist732]

Is the red connector jst connector? Same as traxxas?

[@LYSStuff]

Hi, is a JST connector, but I think if wanna connect to Traxxas, it need convertor from JST to Traxxas. Hope it helps:)

[@eurobeatmachinist732]

@@LYSStuff thank you, my traxxas summit has jst connectros for light system from factory😃

[@LYSStuff]

Nice, then it should be fine. Welcome and thanks for your support.

[@Indonesia01ian]

Hi My camera have 4 wire GND DM DP 5V Where should I connect the DM and DP cable on my VTX

[@LYSStuff]

Hi, If you're connecting your camera to a Video Transmitter (VTX), DM and DP usually correspond to the positive and negative leads of the video signal.

[@Indonesia01ian]

@@LYSStuff should I connect both of them to Video in VTX?

[@LYSStuff]

At the VTX positive and negative lead/pin

[@Rad_Schuhart]

Hi, I got a TS5823 pro transmitter and an EWRF receiver. In the screen I always see the channel and the GHZ, and I find it a bit annoying. Is it possible to remove it? Thanks!

[@LYSStuff]

I referred to date sheet of the TS5823, I think there is no where to off it, because It use to show user the current channel. Usually I turn the screen side to the back.

[@Rad_Schuhart]

@@LYSStuff Thanks for your immediate answer! Just to be sure, that info comes from the receiver and not from the transmitter, right? I am using this system for super realistic scale FPV and those letters ruins it, so it looks like I have to replace the receiver. The TS5823 seems to be fine though :)

[@LYSStuff]

@@Rad_Schuhart I not sure what is your "that info mean", if for the screen, is the transmitter. The TS5823 is transmitter to FPV receiver. You may refer to this video for receiver kzbin.info/www/bejne/Z57Nl4hpZrx_qtU

[@Rad_Schuhart]

@@LYSStuff "That info" is the channel and radio frequency info which appears in the top of the screen. I saw your other video and that data is not there, but you are using an Skydroid receiver and not an EWRF... so that makes me believe the problem is in the EWRF receiver and not in the transmitter. But anyway, I appreciate a lot your help and time. Thank you!

[@LYSStuff]

@@Rad_Schuhart I see, welcome 👍

[@mr.karthiklegend306]

Bro it's range distance.

[@LYSStuff]

For 200mW, distance range will be 100 meter to 300 meter. For 600mW, distance wlrange will be 400 meter to 600 meter. Hope it helps. :)

[@danielfeitoza8489]

what's the fpv monitor you're using? 2:00

[@LYSStuff]

Hi, Is Monitor 7 Inch LCD5802D You may refer to kzbin.info/www/bejne/jKu1mX-ih9aUatk&si=J-ref1VtuyX7cL7n

[@LYSStuff]

@pajeni8598 yea, u can use skydroid as FPV receiver then connect with phone as display.

[@mamoshimiloni9559]

I know people who have flown 7 or more km's on 600 mw

[@LYSStuff]

Nice, thanks for the information. 👍

[@TuUwU-cd1ui]

Bro solo le pegue al teclado y resulta que hay algo relacionado xd

[@LYSStuff]

Haha, what a coincidence!😆