Extreme Online Store | Corvette C8 Z06 Conversion Front Splitter Lip installed by

[@RadioguyJ]

No way I’m drilling holes into my $100k car to mount some cheap plastic canards.

[@rondail5675]

Nice, but you couldn't get me to drill holes into the fender for the canards.

[@jeffcollins7311]

Drill holes in the bumper 😂 😂😂😂 HELL NO

[@2real4tv70]

I wonder if you could just use the double sided tape for the canards. What if you want to change the splitter later?

[@SK-pn1pe]

I bought this front splitter w/o the canards. The fit was pretty good....was supposed to be carbon flash but I'd say its more of a gloss black....has some tiny metal flake specks in it, but not much. There were some horrible runs in the paint, BUT they were in areas that couldn't be seen once installed so I was ok with it. I had to do some polishing and buffing in some areas of the lip....minor scratches and just poor finishing quality. Overall I'd give them a B- for quality...but they are very cheap in comparison to other brands so there's your trade off. I will also say these sit about 1.5" lower than the factory Z51 splitter....so beware when you are going up driveways or over speed bumps. I have to use the front nose lift far more often with this installed. It does look nice with how low it looks from the front though. I also bought the Z06 side skirts and they look good along with the front splitter. Side skirts had same minor issues....wavy appearance in finish...had a bent corner on one that straightened out with a heat gun. A little work and clean up and they are again B- overall in quality. Carbon flash was much closer to a match with the side skirts I will say. I think EOS is ok overall....just be prepared to do some minor detailing and body work to get them correct.

[@extremeonlinestoreYT]

Thank you for your feedback. We endeavor to give high-quality products at an affordable cost.

[@RichardHawkins-ev3gm]

Which splitter did you have on before the swap?

[@dannyr.7566]

do you have to drill holes on the carnards or is it mandatory?