f100 cab corner repair

[@larryhicks7558]

I agree with you for not cutting extra metal off. I feel you made extra work for yourself when you ground your weld down as you did. I would have hammer and dolly to flatten the centre of the weld . Yes grind the centre but only to touch the metal of the new patch . Now weld will be a lower valley and want a bit of filler. That could of been avoided. I like your tape method. There is less metal to weld in and less heat . To have less warp.

[@1194video]

There are many different ways to go about doing it that was my way I chose on that particular panel but could’ve saved a lot of time of course

[@larryhicks7558]

@@1194video so true

[@kneedeepinbluebells5538]

Compare THIS Youngin' And His SKILLS, To The Millions Of His Fellows With Worthless "Degree's" And Zero Work Ethic - SAD. Bravo Sir !

[@richardmoll6196]

Enjoyed your video. Thanks ! Richard Moll - Waco, Texas

[@1194video]

Hey! Thankyou. Good to hear from you.

[@Duzick_Truck_Shop]

So I found a scribe works best for marking metal to cut out

[@GPDIY]

Top class work as always.

[@dgadver]

Nice work!!!! Where is your shop? Thanks for sharing!

[@1194video]

Tennessee is where we are located but dont do anything for public, its more of a hobby