Federal Signal Vista

Just wanted to show case my Federal Signal Vista lightbar.

[@Guillotines_For_Globalists]

What kind of flasher is that in the rear on the signal master? That's not an original Federal Signal product I'm guessing.

[@ingearango9769]

LA PD las utilizo en el 2004

[@828enigma6]

Nice light bar. Like the way you demonstrate it's features separately and together. What is the current draw with everything lit up?

[@rjracing38]

Thank you, the current draw on each function I will have to let you know as my DC amp clamp is not functioning properly however I can tell you on my switch box, each fuse is a 20amp fuse...which for some of the functions is a bit overkill but I can get the other info to you when I get my amp clamp replaced.

[@kevinjgoff]

Do you have wiring instructions? I have this and cannot figure out the purpose for many of the wires

[@rjracing38]

Depending on how yours is setup but there are a few wiring diagrams that you can find online on google that ill be available for download to show the wiring and what goes to where on your bar or at least a good start. This link here is one version I found for you, hope it helps gives you a good start and baseline for your bar; www.fedsig.com/sites/default/files/resource_library_document/2561340.pdf

[@hogfeederyahoo]

What did you end up using for the power supply?

[@rjracing38]

I used a Tripp Lite PR60 DC power supply for my setup.

[@chrisratuszny402]

What controller did you use?

[@rjracing38]

This particular bar I had setup a Federal Signal SW400 switch box.

[@dunc_n_fr]

How can I replace one of the domes?

[@rjracing38]

Chief Ray , there's should be about 5 hex screws I believe on the outer domes you loosen and then you'll be able to pull the domes right off, or if you're trying to replace the center dome, should be 4 screws holding that one.