Best thing I did today was subscribed to your Chanel
@dnmautolocksmith4618 Жыл бұрын
Thank you
@stein-arnefalchpedersen2222 Жыл бұрын
Good job! Thank you for sharing 🙏
@dnmautolocksmith4618 Жыл бұрын
Thank you
@inagbihal8518 Жыл бұрын
Would the battery disconnect work if only the new key remote didn't work but the original did please?
@PavLockLocksmith Жыл бұрын
What was a year? I have 2019 on Tuesday first time
@mhamedabuhdaieb46612 жыл бұрын
When you generate the xhorse key you do one time or you need to generate the remote separate and the chip separate?
@dnmautolocksmith46182 жыл бұрын
Sorry late reply I used kd remote just do it once
@edgardavidcespedescamargo6115 Жыл бұрын
Do you mind sharing the kd controller that you use , I am doing it with kd but not working, probably I am doing it with a wrong software.
@kevindean96132 жыл бұрын
Thanks for the video , How did you know what immo number to pick ?
@edgardavidcespedescamargo6115 Жыл бұрын
Good question
@constantinnicolaescu5333 Жыл бұрын
Did you prepared the remote first with kd x2 ? Or you put the key in the programmer and generated the dealer key ?
@dnmautolocksmith4618 Жыл бұрын
Yes you prepare the key with kd then put in the programmer and make the dealer key then program to the car
@Nery_00 Жыл бұрын
Did you unplugged the battery i didnt see you did it ?
@dnmautolocksmith4618 Жыл бұрын
Yes I pulled the main earth lead off about 7.05
@Nery_00 Жыл бұрын
@@dnmautolocksmith4618 seconds?
@YankTank Жыл бұрын
Can you program a dealer key with xp200?
@dnmautolocksmith4618 Жыл бұрын
Unsure I only use the xp400 but I would think so
@guapo45182 жыл бұрын
What model of new remote did you use?
@dnmautolocksmith46182 жыл бұрын
Kd NB remote
@daromani Жыл бұрын
Hi, thanks for your video, it provides some important details that are either missing or glossed over by other videos I have viewed on this subject. I am using a Topdon T-Ninja 1000 keyfob programmig machine to attempt to do same as what you did in your video. This machine is capable of doing all the steps you demonstrated with your IM508 setup, as you can see in this video: kzbin.info/www/bejne/jHatfneCr6pgd68 I purchased on eBay a new aftermarket keyfob that was advertised as compatible with my keyfob's FCC code LTQFI2AM433TX. Everything works as per your video, except that when I try to do the "make dealer key" step, it fails with message "The chip is locked, and the dealer key cannot be generated". So I purchased a LTQFI2AM433TX-compatible replacement PCB on Aliexpress, swapped it into my keyfob, and tried again And again, the "make dealer key" step fails with message "The chip is locked". I am curious to know what is causing this failure, and is there anything I can do to make it work? Thanks.