First Engine Start After the Overhaul

[@rockers2rockers616]

Congratulations Gareth on a job well done considering you do this by yourself especially the refresh of the rear end all done without a hoist. Best E36 channel on KZbin.

[@GarethFoley]

Thank you. It's been a much longer and more involved build that I originally planned for. Doing it on stands without much assistance has also been a challenge at times but it will make it that much more worth it once I take it for the shake down.

[@errickdevan4373]

Looking good man, it’s coming along nicely.

[@GarethFoley]

Thanks man. It's come together pretty quickly since spring got here. Only thing that has held me up so far has been the frequent rain in May.

[@mariok4610]

Is it ok to use iat sensor in intake boot not in manifold as stock location? Any differences?

[@jacquesmorley8372]

Hi mate, what torque wrench do you use?

[@GarethFoley]

Gearwrench 3/8" drive, 30-250 in/lbs (3.5Nm-28Nm) range. I believe it's currently sold as p/n 85061. Mine is an older number but looks the same.