Every Boat Should Have One!! or Two!

[@chrisdoran7596]

Congrats on 90000 subscribers Timmy.

[@Maginnifix]

Wow ive watched you since the plywood floaty thing you built you have come along ways 😊

[@chrisfitzbayside8638]

Bring back the pipe boat❤ that thing was sick

[@FNQOutdoorAdventures]

Didn't even know what they were used for until now 😂. Cheers bro

[@johnharris7866]

Welcome back

[@kimyoung4554]

Hello from the North Beach crew 😮😅

[@roryvinnicombe8796]

Hey @timmy, I have a similar centre console in WA and looking to repower, are you happy with the fuel economy are you getting from the V8? I’m underpowered but getting similar figures to you from my DF 175 Suzuki at 22kts, I’m more interested in increasing my range rather speed, so leaning towards a jack plate with a v6 225 merc which being lighter than the Suzuki should help. Any advice?

[@skydoesyourmom9962]

You might see this but I would love for you to do a series for a 1m flatty it would be amazing

[@6knots6]

Howdy , how are you finding the boat , any issues ect

[@YTFishingKif]

Waw nice mister boat fishing good😍😍👍🏻👍🏻👍🏻

[@boihat]

nice boat timmy. would you install permatrim and a sharrow propeller? i'm curious how your boat (or any other boat) would react to all these impressive upgrades. cheers mate

[@MrNcrumble]

Good run down mate, if I get in the market I'll check em out. If they're supporting you that's reason enough to have them on the short list.

[@christianmorriswilliams7072]

Timmy why don't you get George to make the skiff you made a couple years back from aluminum.

[@furphyslaw1]

Hey mate, interested to know how much speed you gain from trimming it right up compared to all the way down? Whats the fastest you've ever reached?

[@davessparetime83]

The higher the jackplate the less trim you need. A high rooster tail means you are shooting water up instead of straight back. With both jackplate and power trim you need to adjust both at the same time as you are taking off.

[@davessparetime83]

You can't compare jack plate lowest setting to transom height. Because the setback is so far away from the transom it puts the prop even lower when taking off. The rear of the boat being the fulcrum. Raise Jackplate mount inch per foot of setback.

[@bigbarracreekaussie3449]

George again,that's one beast of a boat the old boy rules.

[@christianmorriswilliams7072]

Timmy don't go missing again 4 months now and no upload from you.

[@ladstopendadeventures8237]

How big is his boat

[@dante7228]

I wouldn't mind also having a boat to attach it to...otherwise it's a little bit useless 😂

[@dolphintouchmichellepsychi6217]

Hey Timmy you know to mention Mills is a red healer???? No more said.... I would love a doggy like Mills... QLD is not a good state....

[@travsfishnsafaris7315]

How good

[@brettellis1837]

Be good to have a good 500.000 in bank now. 😂 but back to lotto study . Got to love the new. Technology ..

[@andrewshackleton3700]

Has he give a dollar figure for the build cost ….?

[@bobgeldof1038]

That's all well and good Timmy but where's the fishing adventure vid mate...

[@derkmendeish5390]

Bruh! You related to Scott Pendlebury or wahh

[@theoriginalhatchy]

Turtle your maths is wrong. It’ll take 11.24km to save 1L fuel. That’s worked on 1.4km/L vs 1.6km/L Or over 50km stretch it’s 35.7L vs 31.25L Unless you meant L/Km and then I’ll go back to the drawing board

[@joangeddes380]

❤️❤️‍🔥💙🩵💚😘🤗

[@darat-m]

I think you can do it better than this, especially every small thing on your product ❤❤❤❤❤❤❤❤❤❤

[@getspooled1233]

first

[@Iamtherealjerkfreak]

That’s what you’re girl never says in bed right?