I fixed the P1391 check engine code by replacing camshaft position sensor. This is a quick simple job.
Пікірлер: 16
@chadhewins7546 ай бұрын
Thanks for the video. I really appreciate you showing the install with the engine in the vehicle. Most similar videos show the install on an engine out of the vehicle.
@41GarageandGrill6 ай бұрын
Awesome! Glad it helped! Thanks for watching!
@keithcrum2310 Жыл бұрын
Great job
@41GarageandGrill Жыл бұрын
thanks
@Myrtlecrack8 ай бұрын
How did you know it was the Camshaft sensor, and not the crankshaft sensor? I'm asking because I have the same code and an intermittent no spark situation on a 99 Jeep XJ.
@41GarageandGrill8 ай бұрын
Based on the symptoms I was having and the reading of forums seemed to all point to that. I wasn't 100% sure it would fix it but seemed like the most likely and easiest/cheapest place to start.
@jenkinsjohnkid8 ай бұрын
Is the replacement of the Camshaft Synchronizer a critical replacement with the sensor?
@41GarageandGrill8 ай бұрын
yes it will cause the engine to not run properly if at all. may leave you stranded somewhere if you don't fix it. thanks for watching keep me posted
@WinModel8811 ай бұрын
I have a 96 Cherokee with the 4.0 and i get that P1391 code only when I use the passing gear and get the RPMs up. It comes on every time i run it hard. Never when i drive it gently lol. I clear the code and it comes back when I'm hard on it. Runs fine other than a slight rough idle now and then. Could this be a cam or crank sensor issue?
@41GarageandGrill11 ай бұрын
Nice! like all Cherokees, they just need their feelings massaged lol. thanks for watching and sharing about your Jeep!
@WinModel8811 ай бұрын
@@41GarageandGrill oh you're welcome man lol. But does this sound like a cam or crank sensor issue in your experience?
@41GarageandGrill11 ай бұрын
@@WinModel88 So you symptoms sound a little different even though it could be the same part failing. I would hook up a code reader and try to get the code when you are driving and it comes on.
@WinModel8811 ай бұрын
@@41GarageandGrill I get the P1391 code.
@41GarageandGrill11 ай бұрын
@@WinModel88 I would go ahead and replace it then. It's possible there's enough play in it that as the RPM comes up it gets out of alignment
@pano_0380 Жыл бұрын
What are the symptoms of a bad camshaft position sensor?