Focus RS Goodridge Brakeline install and Motul RBF600 Fluid

After successfully replacing my buddy's rear axle in the last video, I am now replacing my brake lines and the brake fluid in preparation for the next track day at COTA, which will be on November 18th.
I chose to change the brake lines because I knew that I had cooked the brake fluid and as a result, caused likely damage to the factory brake lines due to its age, abuse from the track, and the boiled brake fluid.
Camera: GoPro Hero4 w/ EDUTIGE ETM-001 Microphone
Canon Rebel EOS Rebel T7i w/ Rode Universal Mic
Instagram: nick_ucars
Twitch: Nick_UCARS
Tuner:
Alex from Stratified Auto Controls
www.stratifiedauto.com/index.php
Sponsor:
CR3 Motorsports
cr3motorsports.com/
2017 Focus RS Mods:
VelossaTech Snorkel
K&N Drop-in Filter
NGK Iridium Spark Plugs
Radium Breather Plate
ETS Intercooler (Black)
Borla Catted-Downpipe
Borla S-Type Cat-back Exhaust
TurboSmart IWA
Stratified X4tra Fuel System
Stratified Guardian Angel
Full Blown Motorsports Ethanol Content Sensor
GrimmSpeed Front License Plate Relocator
GrimmSpeed Exhaust valve delete (plug)
Damond Rear Motor Mount
Quaife LSD
JacksTransmissions Gear Shaft Steel Cage Bearings
SynchroTech Carbon Synchro's
ACT Streetlite Flywheel
ACT Six Puck Ceramic Sprung disk
ACT Pressure Plate
Fortune Auto 500 Coilovers
FSWerks Rear Strut Tower Brace
Michelin Pilot Sport 4S Tires
CPE Tial BOV Exhale BOV Kit
DiodeDynamics SLF LED Fog Lights
Enkei NT03 ++ 5x108 43mm (Gloss White)
StopTech Slotted Rotors
Hawk Performance 5.0 Street Pads
Mountune Triple Bypass Radiator
GoodRidge Blue Steel Braided Brake lines

[@gbass7328]

A good start. But Castrol SRF is race team used. A synthetic fluid but still DOT4.

[@Nick_UCARS]

If the Motul Fluid doesn't do too well in the next testing/Track day, I will be switching to the Castrol SRF.

[@phxroadracer]

Thanks for the video. I'm going to tackle this project this week myself. Wish me luck. Just curious, would it be easier to vacuum the fluid out of the system prior to starting the replacement?

[@Nick_UCARS]

I found it easy to just vacuum pull the fluid while refilling the reservoir to make sure I don’t put any bubbles in the system. It makes it a whole lot faster of a process. There’s even a method where you use the ABS system to push the fluid out as well.