Ford 1.0 Ecoboost Crank Pulley Torque Procedure

Just a little video on the Torquing procedure of the Crank Pulley Bolt on the Ford 1.0 Ecoboost engine, this is using genuine Ford tooling and procedure. I hope this helps someone looking to do this job themselves
Thank you for watching
Please like and subscribe
Torque Wrench Used is a Snap On Tech Angle
@SnaponToolsOfficial
@mactoolsvideos
@AutelTools
@Drivetribe
@quickjackusa
@topdoneurope-diagnostictoo1296
@sealeytools
@KZbin
@MrBeast
#mechanic #mechanical #mech #auto #autoworks #automotive #repair #maintenance #diagnostic #service #vehiclerepairs #vehiclerepair #diag #car #carrepairs #bridlington #yorkshire #eastyorkshire #youtubeare
#youtubelikes #subscriber #youtubeguru#newvide #youtubeconten #youyube #youtube #youtubeislif #subscriber #youtu #youtubevideo #youtubevideos #youtubevideo #youtubechannel #continental #lassa #michelin #kumho #pirelli #insta #instagram #dunlop #uniroyal #massimo #viral #newvideo #youtubechannel #youtube #share #youtubers #love #music #vlog #subscribe

[@cistokrvnibosanac1266]

thank you

[@alunbignell1173]

At last the correct way to torque up that crank bolt

[@someone7507]

To manage without the torque multiplier you need to know what is the multiplication level of the tool, and for one full revolution (360 degs) how many degrees the tool has on the output. So if the tool is 5:1 and the first torque setting is 60 Nm, then on the bolt the torque shall be 300Nm. Then, for the 5 x 90degs on the input you can figure out the angle on the bolt. If the nice gentlemen who filmed this video, provides the torque multiplication and input/output angles of the tool, this job could be done without the torque multiplier. BUT, the need of a larger torque wrench + a breaking bar might be needed to achieve the high torque + the angle of the bolt. Cheers, and please correct me if I got something wrong.

[@william8108]

What happened to the 300 nm plus 90 degrees part?

[@MandJAutomotive]

This is the correct torque setting specified by Ford buddy

[@william8108]

@@MandJAutomotive See the Haynes manual buddy.

[@MandJAutomotive]

Mine comes direct from Ford who manufactures the engine

[@andrewgordon7489]

Tight is tight

[@prawny12009]

The video for the Lazer tool shows 25nm - 70nm then 90° X 4 then 25° using a 9-1 torque multiplier. The ford procedure says to torque to 60nm using the multiplier before moving on to angle tightening of 90° X five. Lazers version equates to just 70nm + 82.77°

[@yorkeyparaglides]

Is the Ford multiplier 9 to 1 as well? TIA

[@brbroberts1]

The Rotunda 303-1611 is 1:5x. This is the Ford tool, Rotunda manufactures many tools for Ford

[@trofinmarius4614]

If you own that tool it s fine, if you don t ..definetly not worth buying it!, you can manage without it

[@stephenrichardson6105]

How do you do it 🤔 Thinking of doing lads 1ltr eco boost Believe way without is 330Nm them 90