Ford 5600 Power steering pump removal and install

[@gulabkhan2639]

Good morning ❤️ and your tractor very nice

[@robertl.180]

Hello, my 6610 tractor is leaking oil. Please do you know how I can find the part code or the name of the media gasket that you commented at minute 3:23?

[@FatChanceFarmstead]

If it's the same one I referenced in the video then you know that I didn't bother to locate a new one and just used the old one. But just call your local New Holland parts department and I'm sure they can locate one for you.

[@stephanecome4234]

Thanks for sharing. I think I need to replace mine. I’m going to check the pressure this weekend. What kind of fluid do you use?

[@FatChanceFarmstead]

That's a good question. Some people suggest the same oil you put in the engine incase they mix, but I use hydraulic fluid. Before you replace the pump though get your hands on a rebuild kit and replace all the seals as that may fix your problem (assuming the problem is that it's leaking). This aftermarket pump I have is not as well built and new holland doesn't make them anymore.

[@johnrobinson2074]

That pump you replaced, is that also where the fluid goes and do u fill it all the way to the top?

[@FatChanceFarmstead]

Yes and yes.

[@johnrobinson2074]

@@FatChanceFarmstead ok last question on the opposite side of the tractor in front of the fuel pump...what is that. And does it takes hydraulic fluid. I took the top off and it has gears inside

[@FatChanceFarmstead]

@@johnrobinson2074 I'd need to see a picture as there were a few different injector pumps fitted onto these tractors. One type requires oil.

[@parchechuletaovero9507]

Hoy long have You been working with the loader ?

[@FatChanceFarmstead]

Not sure what you mean. But the loader has been on the tractor for maybe 5 years.

[@parchechuletaovero9507]

@@FatChanceFarmstead is the front axle strong enough for loader work? I'm thinking to install a loader in my Ford 6600

[@FatChanceFarmstead]

@@parchechuletaovero9507 aaah I see. Yes it is strong enough for some work but I wouldn't be moving heavy loads of sand or gravel over and over. If your 6600 is 4x4 that's a different story but those 2 wheel drive tractors arent built for heavy lifting. Make sure those front wheel bearings are tight. Goodluck.

[@edsimpson9639]

where did you buy your pump? thanks

[@FatChanceFarmstead]

Hey Ed, got this on Ebay from Georgia. It's an aftermarket, not gonna last aslong as the original from what i can tell. I kept my old one incase this one doesnt last and may try and rebuild it.