Ford EcoBoost 1.0 How to Install a New Thermostat

Ford EcoBoost 1.0 How to Install a New Thermostat

[@OlDavey]

Did you need to use sealant or did the housing have its own rubber seal?

[@quayzessj425]

Its a 90 degrees or 50 degrees température ?

[@tplubbs3629]

I'm just abouts to do this task as my temp bars are stuck at 2 and 3, where before it was a solid 4 consistently when fully warm, also start stop will not trigger as I assume the engine temp is too low. Question, was there any special procedure to refilling the coolant? Were you able to save a lot of the coolant or did you lose it all?

[@vrijemezabave]

i save almost all coolant ....

[@DanielSmith-hi2jw]

@@vrijemezabave did you have to drain the coolant first or is it just a small spill?

[@t.y.thetruth883]

what tool did you use?

[@JmChannel25]

Did you bleed the cooling system after the change. If yes, how? 🙂

[@vrijemezabave]

after the change, I topped up the coolant that I saved during removal. After the engine warmed up and pulled into the system what it needed, I filled the container as much as it needed, which was half a liter

[@satanhimself3647]

From where did you get the part? My thermostat housing is broken but I can't find it here in India..

[@vrijemezabave]

Ebay ... genuine part..60eur I can send you picture

[@justin8750]

Could you please provide the link for this part? I've looked for two day's & can't even receive it from the dealership for 3 week's. Thank you for your help.

[@sammyk6765]

Have you got the part number

[@edtwin88]

What was your trouble code .. great video

[@vrijemezabave]

there was no mistake. the temperature dropped while driving and he did not want to heat the cabin

[@kalebcadman9868]

Did you drain the coolant first?

[@vrijemezabave]

No

[@thomassaunders7053]

Ya what tool is that?

[@medlock613]

It's a 47 star, I believe.

[@touchme170]

Shame you didn't talk through the video, Just an observation not a dig at you 5*

[@diddyd8350]

How to fit a thermostat by spending a minute looking at a binacle.

[@petesabout]

This has to be the worst "How to" ever. Don't even watch it.

[@jussumwhiteguy]

Helped me with mine.

[@ibo1137]

I think it was pretty goodl.