Ford Ranger Solid Axle 5.0 Swap Update (Gears, Lockers, Wiring, and More!)

Just a small update on the ford ranger build. The front gears are done, have finished the truck wiring, and am about to do some valve adjustments

[@brevanhansen5084]

37s?!? That'll be one mean ranger! Isn't that only a d30 axle though?

[@shadytreekustomz6268]

Hp 44

[@brevanhansen5084]

@@shadytreekustomz6268 ok yeah a 44 should handle it... May need a truss but it'll be better than a d30

[@shadytreekustomz6268]

@@brevanhansen5084 I hope so, it does share a few Dana 30 aspects like axle u joints but atleast the gears probably will be fine. This is the cast wedge version of the Dana 44 so unless I ditch the radius arm setup a truss would be hard to do, the tubes are sleeved though when it was shortened, equates to about 1/2 inch tubes now